JVC GR-SXM265AS, GR-SXM301AS Connections To a TV/VCR, Using The Cassette Adapter, Tape Dubbing

•If the playback picture is distorted when TBC is set to on, turn off TBC.

Connections To A TV/VCR

1)Make sure all units are turned off.

2)Connect the camcorder to a TV or VCR. If using both TV and VCR, connect the VCR output to the TV input.

3)Turn on all units. Set the VCR to its AUX input mode, and set the TV to its VIDEO mode.

•Use the AC Adapter as the power supply.

•The S-Video cable connection can improve the dubbed picture quality. A commercially available S-Video cable is required.

•Be sure to lower the TV volume to its minimum to avoid a sudden burst of sound when the camcorder is turned on.

•If you have a TV or speakers that are not specially shielded, do not place the speakers adjacent to the TV as interference will occur in the camcorder playback picture.

To S-Video	White to Audio
Output 6
	Output 7

•	Repeat steps 2) through 4) for additional	FEATURES
cassette recorded with this camcorder on a S-
	editing, then stop the VCR and camcorder
	when finished.
Using The Cassette Adapter
Use this to play back an S-VHS-C/VHS-C video
VHS/ VHS VCR.		BASIC
1)	compartment door 2.
	Slide the latch 1 to open the compartment

door, then insert the cassette and close the

•If the colour shown in the window 4 is green or red, turn the dial 5 in the direction of “UNLOADING” so that colour changes to blue.

2)Turn the dial 5 in the direction of “LOADING” all the way until it stops.

•The color shown in the window 4 changes from blue \ red \ green (indicating playback is possible).

3)Load the cassette adapter into the VCR and play the tape back.

•To record on a VCR using a compact cassette and the adapter, cover the adapter’s recording

safety hole with Adhesive tape.

Connector

Cover

S-Video cable (Optional)

TV

To S-Video

Input

VCR

Yellow to Video

Output 8

A/V cable

White to

Audio Input

direction of “UNLOADING” all the way until it stops.

• The color shown in the window 4 changes from green \ red \ blue (indicating unloading is possible).

5)Slide the latch 1 to open the compartment door, then insert your finger in the hole 6, and push up and remove the cassette.

6)Close the compartment door 2.

2 Compartment door

4 Window

Recording
safety hole	5 Dial

Yellow to

Video Input

Tape Dubbing

1)Connect the camcorder and the VCR (pg.

11, “Connections To A TV/VCR”). Set the Power Switch $ to “PLAY” while pressing down the Lock Button #, turn on the VCR’s power, and insert the appropriate cassettes in the camcorder and the VCR.

Engage the VCR’s AUX and Record-Pause modes.

2)Press 3/8 ( to find a spot just before the edit- in point. Once it is reached, press 3/8 ( again.

3)Press 3/8 ( and engage the VCR’s Record mode.

4)Engage the VCR’s Record-Pause mode and press 3/8 (.

The protec-

tion sheet is

1 Latch affixed

3 Gear

7 Reels

Compact video cassette

6 Hole

•If there is slack in the video tape when inserting the compact cassette into the

11