JVC GY-HD100, GY-HD101 manual Remarque, Port Cable Length

Page 3

Important Safety Instructions

Important Safety Instructions

FOR USA AND CANADA

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK).

NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

The lightning flash with arrowhead symbol, within an equilateral triangle is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.

The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appli- ance.

INFORMATION FOR USA

INFORMATION:

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmfull interfrence to radio communi- cations. However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

zReorient or relocate the receiving antenna.

zIncrease the separation between the equipment and receiver.

zConnect the equipment into an outlet on a circuit different from that to which the receiver is connected.

zConsult the dealer or an experienced radio/TV technician for help.

CAUTION:

CHANGES OR MODIFICATIONS NOT APPROVED BY JVC COULD VOID USER’S AUTHORITY TO OPERATE THE EQUIPMENT.

THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES.

OPERATION IS SUBJECT TO THE FOLLOWING TWO CON- DITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.

INFORMATION (FOR CANADA) RENSEIGNEMENT (POUR CANADA)

WARNING:

TO REDUCE THE RISK OF FIRE OR ELEC- TRIC SHOCK, DO NOT EXPOSE THIS APPLI- ANCE TO RAIN OR MOISTURE.

This unit should be used with 7V DC only.

CAUTION:

To prevent electric shocks and fire hazards, do NOT use any other power source.

NOTE:

The rating plate (serial number plate) is on the bottom of the unit.

CAUTION:

To prevent electric shock, do not open the cabinet. No user ser- viceable parts inside. Refer servicing to qualified service person- nel.

AVERTISSEMENT :

POUR EVITER LES RISQUES D’INCENDIE OU D’ELECTROCUTION, NE PAS EXPOSER L’APPAREIL A L’HUMIDITE OU A LA PLUIE.

Ce magnétoscope ne doit être utilisé que sur du cou- rant direct en 7V.

ATTENTION :

Afin d’eviter tout resque d’incendie ou d’électrocu- tion, ne pas utillser d’autres sources d’alimentation électrique.

REMARQUE:

La plaque signalétique (plaque du numéro desérie) est située sur le cadre inférieur de l’unité.

Due to design modfications, data given in this instruction book are subject to possible change without prior notice.

The apparatus shall not be exposed to dripping or splashing and that no objects filled with liquids, such as vases, shall be placed close to the apparatus.

Worded - “CAUTION - Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.”

FOR EUROPE

This equipment is in conformity with the provisions and protection requirements of the corresponding European Directives.

This equipment is designed for professional video appliances and can be used in the following environments:

zresidential area (in houses)

zcommercial and light industry; e.g. offices or theatres

zurban outdoors

In order to keep the best performance and furthermore for electro- magnetic compatibility we recommend to use cables not exceeding the following length:

Camera

Port

Cable

Length

DC IN

Exclusive Cable

2 m

INPUT1/2

Shielded Cable

3 m

LINE OUTPUT

Shielded Cable

1.5 m

PHONES 1/2

Shielded Cable

2 m

VIDEO/Y,PB,PR

Shielded Cable

3 m

IEEE1394

Exclusive Cable

4.5 m

(HDV/DV)

 

 

AC ADAPTER

Port

Cable

Length

DC OUT

Exclusive Cable

2 m

 

 

 

AC IN

Exclusive Cable

2 m

The inrush current of the apparatus is 7 amperes.

Caution: Where there are strong electromagnetic waves or magne- tism, for example near a radio or TV transmitter, transformer, motor, etc., the picture and the sound may be disturbed. In such case, please keep the apparatus away from the sources of the disturbance.

WARNING:

TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.

This unit should be used with 7V DC only.

CAUTION:

To prevent electric shocks and fire hazards, do NOT use any other power source.

NOTE:

The rating plate (serial number plate) is on the bottom of the unit.

CAUTION:

To prevent electric shock, do not open the cabinet. No user ser- viceable parts inside. Refer servicing to qualified service person- nel.

Due to design modifications, data given in this instruction book are subject to possible change without prior notice.

The apparatus shall not be exposed to dripping or splashing and that no objects filled with liquids, such as vases, shall be placed close to the apparatus.

Worded - “CAUTION - Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.”

Caution for AC Mains Lead

FOR YOUR SAFETY PLEASE READ THE FOLLOWING TEXT CAREFULLY.

Appropriate mains cable must be used in each local area, since the other type of mains cable is not suitable.

FOR CONTINENTAL EUROPE, ETC.

Not to be used in the U.K.

FOR U.K. ONLY

If the plug supplied is not suitable for your socket outlet, it should be cut off and appropriate one fitted.

This Class B digital apparatus complies with Canadian ICES- 003.

Cet appareil numerique de la Class B est conforme a la norme NMB-003 du Canada.

II

III

Image 3
Contents For Customer Use GY-HD101Important Safety Instructions Port Cable Length RemarqueAccessories Main FeaturesContents Routine and Periodical Mainte- nance Precautions for Proper UsePrecautions for Use of Head Cleaning Tape IntroductionCondensation Battery Pack to be UsedCharacteristic CCD Phenomena Videocassette to be UsedMemo Zoom Lens OptionalFront Section Th16 x 5.5BRMULCD Door Rear SectionRight Side Section Top Section Left Side SectionKPLAY/STILL Play/still button GVTR VTR indicator„ Status Screens FDISPLAY Display buttonIndications on the LCD Monitor and in the Viewfinder Cont’d „ Status Screens in the Camera ModeSetting Status Contents of Indications ContentsND1 Filter ND1 1/4ND Indication Indication Contents „ Status Screen in VTR Mode„ Safety Zone Indication Camera mode only „ Auto White Balance Indication Camera mode only„ Menu Setting Screen „ Alarm Message DisplayAttaching the Zoom Lens Provided How to Attach the ViewfinderPreparations Basic SystemInserting an SD Memory Card AC OperationAbout the Viewfinder Cable Battery Operation Turning the Power on Preparations for OperationLoading/Unloading the Cassette Setting and Displaying the Date and Time „ Setting the Date and Time„ Setting the Date and Time Style Displaying Time Code Presetting and Recording of Time Code„ Setting Drop frame/Non-drop frame modePresetting and Recording of Time Code Cont’d Screen AdjustmentViewfinder Adjustment White Balance Adjustment Back Focus AdjustmentSetting the Video Format Camera SettingsScreen Size 43/169 Mode Selection „ Selecting the CH-2 channel input con Nector Audio Input Signal Selection„ Selecting the audio signal input „ Adjusting Audio during RecordingBasic Recording Operation Shooting Operation„ Executing the Header REC Function „ How to set the Header REC menu screenFunction/Initial Setting Header REC FunctionFast-Forward, Rewind Playback ModePlayback Procedure Outputting Audio„ Displaying Alarms Using External ComponentsConnecting the Video Signal Cables Dubbing with AV Devices „ Connecting the IEEE1394 CableConnect the units with the IEEE1394 cable HDV/DV DubbingBackup Recording Menu Screen ConfigurationMenu Screens TOP Menu Screen Setting Menu ScreensVideo Format Menu Screen Camera Process 1/2 Menu Screen Camera Operation Menu ScreenStandard Camera Process 2/2 Menu ScreenAdvanced Process Menu Screen 108%Color Matrix Adjust Menu Screen Skin Color Adjust Menu ScreenSwitch Mode Menu Screen Blue AUDIO/MIC Menu ScreenLCD/VF 1/3 Menu Screen MIXTC/UB LCD/VF 2/3 Menu ScreenLCD/VF 3/3 Menu Screen Tape RemainExecute DisableTC/UB/CLOCK Menu Screen Header REC Menu ScreenOthers 1/2 Menu Screen TIME/DATE Menu Screen„ Displaying the File Manage menu Screen „ Loading a menu settings fileOthers 2/2 Menu Screen File Manage Menu ScreenFile Manage Menu Screen Cont’d „ Setting the skin detail function color and range Features of the Camera SectionHow to Use Skin Detail „ Using the Skin Detail FunctionOthers Outputting color barsDisplay Status Action Blinking Pattern Remaining Battery/Tape Error Code Error Details GY-HD100 Operation RemedyTroubleshooting How to Display the Hour MeterInformation for Users on Disposal of Old Equipment HDV Specifications