JVC GR-SXM780A, GR-SXM78EA Playback Zoom, Animation And Time-Lapse, Insert Editing, Audio Dubbing

Playback Zoom

To magnify the recorded image up to 10X at any time during playback. Make sure that the TBC mode is activated.

1)Press PLAYTto find the scene of interest.

2)Press ZOOM (T/W) R. Pressing T zooms in. To end zoom press and hold W until magnification

returns to normal. Or, press STOP Uand then press PLAY .

•Due to digital image processing, the quality of the image may suffer.

Animation And Time-Lapse

The remote control lets you set/release interval time and recording time without setting REC TIME/ INT. TIME (
pg. 21) in SYSTEM MENU.

Animation

Each time ANIM. Ois pressed, the recording time changes in the following order: 1/4S, 1/2S, 1S, 5S and no indication (off).

Time-Lapse

Each time REC TIME Ois pressed, the recording time changes in the following order: 1/4S, 1/2S, 1S,f5S and no indication (off). Each time INT. TIME

is pressed, the interval time changes in the following order: 15S, 30S, 1MIN, 5MIN and no indication (off).

Insert Editing

You can record a new scene onto a previously recorded tape. Only the video signal is recorded in this mode.

1)Set the Power Switch @to “ ”.

2)Play back the tape, locate the edit-out point and )press PAUSE s. Press and hold COUNTER R/M

for more than 1 second to reset the tape counter, then pre s it again for less than 1 second so that “M” appears.

3)Press REW Yto go a little beyond the beginning of the scene you want to replace, press PLAY T to view the recorded tape, and press PAUSE s exactly at the edit-in point where the new scene should start.

4)While holding down INSERT I, press and release PAUSE s. w appears.

5) To begin Insert Editing, press START/STOP . When the counter reaches “0:00:00”, editing stops automatically and the camcorder enters the Insert-Pause mode. To end Insert Editing, press STOP U.

•During Insert Editing, the original audio will be heard from the speaker.

•After step 4), “Retake” (
pg. 13) can be performed.

•The tape may stop slightly before or after the designated end point, and noise bars may appear. Neither indicates a defect in the unit.

Audio Dubbing

You can record a new oundtrack on a prere- corded tape (normal audio only). The sound is recorded from the built-in microphone.

Perform steps 1) and 2) of the Insert Editing procedure.

3)Press REW Yto go a little beyond the beginning of the scene onto which you want to dub the new audio, press PLAY Tto view the recorded tape, then press PAUSE sat ex ctly the point where dubbing should tart.

4)While holding down A. DUB d, press and release PAUSE s.

5)To begin Audio Dubbing, press PLAY T. When the counter reaches “0:00:00”, Audio Dubbing stops automatically and the camcorder enters the Audio Dub-Standby mode. To end Audio Dubbing, press STOP U.

•Do not press REW Yor FF aduring Audio Dub- Standby, or the edit points will not be accurate.

•If the microphone is too close to the TV, or if the TV’s volume is too high, whistling or howling may occur.

For Insert Editing/Audio Dubbing

•Insert Editing and Audio Dubbing may not work correctly if the tape contains blank segments, or if the recording speed was changed during the original recording.

•To edit/dub onto a tape, make sure the erase protection tab is in the position that allows recording.

•Do not press STOP Uduring Insert Editing or Audio Dubbing, or the edit points will not be accurate.

25