JVC GY-DV301, GY-DV300 Battery Pack Operation Cont’d, Remaining Battery Power Indication

Page 35

Battery Pack Operation (Cont’d)

Remaining Battery Power Indication

TALLY lamp

The remaining battery power condition can be checked

by the remaining battery power indication on the LCD

 

 

 

 

screen and the TALLY lamp.

 

 

 

The battery condition is indicated as shown in the table

 

 

below. Prepare for battery pack replacement in

 

 

accordance with the indications.

 

 

 

Indication

Remaining

 

LCD screen

LCD Screen Tally Lamp

Battery Power

 

 

Remaining battery

 

 

 

 

Remaining battery

power is low.

 

 

Prepare or replace

 

power indication

 

 

 

with a fully charged

 

 

 

 

 

 

battery pack.

 

Fully

Slow blinking

No remaining bat-

 

(1 blink per

tery power.

 

charged

second)

Immediately replace

 

 

with a fully charged

After the remaining battery power indication

 

Blinking

battery pack.

starts blinking, recording can be continued for

After the no remaining battery power warning appears,

approx. 5 minutes. (when BN-V428 is used)

 

 

the GY-DV300 automatically stops operation if the

Operating Time with Battery Pack

battery power operation is continued.

 

 

Battery

Continuous Operating Time (25°C)

When a fully charged battery pack is attached, the

approximate continuous operating time is as shown

Pack

GY-DV300 only When KA-DV300 in use

in the table on the left.

 

BN-V428 Approx. 120 min. Approx. 80 min.

Battery operating time may differ depending on the

number of times the battery has been charged,

 

 

 

 

charging conditions and the operating environment,

 

 

etc. Regard the values in the table on the left as

 

 

approximate reference times.

 

 

 

Operating time is reduced in areas with a cold

 

 

environment.

 

 

 

Operating time is reduced when the power zoom

 

 

lens is used frequently and when start/stop of

PRECAUTIONS FOR THE BATTERY

recording is performed frequently.

PACK

 

 

 

When the battery pack is not in use, it must be stored in a cool, dry place.

Do not leave the battery pack in a place where it might be subject to high temperatures (under direct sunlight in a car, etc.), as this could cause battery leakage or shorten the service life.

When the terminal section of the battery pack gets dirty, the operating time will be shortened.

If the operating time becomes greatly reduced even immediately after recharging, the service life of the battery pack is nearly finished. Purchase a new battery pack.

Recharging

Recharge the battery pack after completely discharging it. Repeated recharging with residual charge remaining could result in reduced battery capacity.

If the battery capacity is reduced by repeating incomplete recharging, or recharging without discharging, once discharge the battery pack completely, then recharge it to restore the battery capacity.

If the battery pack is recharged with its internal temperature raised immediately after use, recharging may not be performed completely.

E-35

Image 35
Contents GY-DV300 GY-DV301 Port Cable Lenght These instructions are for the GY-DV300E and GY-DV301ERemarque This unit should be used with 7V DC onlyAbout the LP Mode Main Features Contents Supply voltage Precautions for Proper UsePrecautions for Proper Use Cont’d Head Cleaning Required Routine and Periodical MaintenanceHead Cleaning Periodical MaintenanceVideocassette to be Used Precautions for Use of Head Cleaning TapeTo record on the tape, slide the switch to REC Switch Moire or Aliasing Characteristic CCD PhenomenaCondensation Smear and BloomingFocus ring Manual focus ring ND. Filter ND-filter switchIris Iris adjustment dial Focus Focus switchViewfinder Viewfinder diopter adjustment knobLCD door LCD door lock release buttonIndicators and Connectors Rear Section Select dial CH-1/CH-2 Audio CH-1/CH-2 audio input selector switchMIC 2 The sound from the MIC 2 input connector is input Menu Menu buttonMemo Indicators and Connectors Rear Section cont’dBAR Colour bar/Playback & still button AW White balance/Stop buttonBuilt-in speaker REV REVERSE/REW buttonLCD monitor screen Earphone Earphone jack Indicators and Connectors Left Side SectionCH-1/CH-2 Line OUT CH-1/CH-2 audio output connector RCA Microphone holder attachment base DV DV connectorCassette cover \ Built-in microphone Built-in monaural microphone Indicators and Connectors Front SectionMIC 1 Microphone 1 input connector XLR- 3P ` MIC 2 Microphone 2 input connector XLR- 3PZoom Zoom lever Indicators and Connectors Top SectionZOOM/Playback sound level adjustment lever Eject Eject switch Status Screens Normal display in the shooting modeBattery symbol Remaining tape time indication appears Indication may not appear when a new tape is loaded, afterTape Remain item on the Display 2/2 menu screen Tape runs, the indication appearsIndications on LCD Screen and Viewfinder Screen Cont’d ContentsEject StbyREC StopVertically inverted display indications in the shooting mode Display 2/2 menu screen Recording/playback VTR playback mode status indicationsSTOP, PLAY, FF, REW, EJECT, STBY, FWD, REV, Bsrh VTR mode indication Indicates status of VTR operation Event Indications Set Condition Contents of Indication Alarm indications  Auto White Balance Indication  Menu Setting ScreenPreparations Basic System DC Input Preparations Power Supply Preparation Set the Power switch on the GY-DV300 to OFF AC OperationAttaching the Battery Pack on the GY-DV300 Preparations Power Supply Preparation cont’dBattery Pack Operation Charging the Battery PackOperating Time with Battery Pack Battery Pack Operation Cont’dRemaining Battery Power Indication Screw Hole Knob Microphone holder Attachment screw Preparations Attaching the Microphone optionalMIC Microphone holder attachment baseViewfinder screen Turning the Power OFFPower switch Mode switch VTRUnloading the Cassette Preparations for Operation Cassette LoadingLoading the Cassette  Viewing the LCD Screen Preparations for Operation LCD Screen Adjustment Adjusting the Direction and Angle of the LCD Screen  Adjusting the LCD Screen Adjustment of the Viewfinder Image Preparations for Operation Adjusting the Viewfinder Adjusting the Position Viewfinder  Diopter AdjustmentGain Shutter Menu Setting, DisplayingSetting the Date and Time Preparations for Operation Recording the Date and TimeTime Hour, min, sec Setting, Displaying and RecordingClock Adjust Preparations for Operation the Date and Time cont’d Display of date and time in the various operation modes Displaying the Time and Date on the ScreenRecording the Date and Time Data Or the viewfinder screen How to charge Preparations for Operation Charging the Built-in BatteryButton Presetting the Time CodeTC Preset screen Preparations for Operation Recording the Time Code Display of the time code in the various operation modes Preparations for Operation the Time Code cont’dDisplaying the Time Code on the Screen Recording the Time CodeManual Shooting Mode Auto/Manual SelectionAbout the Auto and Manual Shooting Modes CAM-A VTR Gain Shutter MenuMode CAM-B Shooting Mode Auto/Manual Selection cont’dHow to Select Either Manual or Auto Shooting Mode Mode switch Menu button Select dialMicrophone connected to the MIC 1 input Audio Input Signal SelectionConnector should be used Select the input signal to the CH-1, CH-2 audio channelsAudio Input Signal Selection cont’d Monitor  The volume of the monitored sound cannot be adjustedAudio Monitor Selection Earphone jackFocus ring Focus Mode SelectionFocus switch Focus Switch Focus AdjustmentHandle Zoom lever SHOOTINGAngle of View Zoom In/Zoom OutZooming Opening the System menu screen Menu Screen SettingsWind CUT MIC1 Audio ModeREC Mode MIC1 Input SELMenu Screen Settings cont’d Shooting Basic Recording Operation Zoom lever  Adjusting the focusShooting Basic Recording Operation cont’d  To rewind the tape in reverse direction Shooting Viewing the Recorded Scene Edit SearchScreen indication during edit search  To advance the tape in forward directionProtection mode is engaged Shooting If the Unit is Left in Recording-Standby ModeBAR button Color bar signal of the built-in signal generatorShooting Recording the Color Bar Iris Auto iris  Engage the recording-standby modeGain Shutter Speed EEIOperation Manual Adjustments Manual Focus AdjustmentAbout Auto Focus Manual Adjustments Manual Focus Adjustment Cont’dMomentarily Using Auto Focus Push Auto Focus buttonFilter indication Manual Adjustments Using ND FilterMenu button AW button Manual Adjustments White BalanceEngaging the Manual White Balance Adjustment Mode Obtaining Natural TintDuring operation Manual White Balance AdjustmentError indication area Press the AW buttonManual iris Manual Adjustments Manual Iris AdjustmentEngaging the Manual Iris Adjustment Mode AdjustmentAdjustment in the auto iris mode Manual Iris AdjustmentMomentarily Using the Auto Iris Mode Step or Variable Manual shutter speed mode indicator Manual Adjustments Manual Shutter Speed AdjustmentShooting a Computer Display Adjusting the Shutter Speed ManuallyLolux indicator Manual Adjustments Manual Gain AdjustmentEngaging the Manual Gain Adjustment Mode Manual gain mode indicatorIndication of set gain value Adjusting the Gain ManuallyGain button Select dial Lolux mode indicator Manual Adjustments Manual Gain Adjustment cont’dEngaging the Lolux Mode with the Gain Button About the Lolux modeOFF Manual Adjustments for AdjustmentSetting Zebra Display Displaying Zebra PatternsCH1 Audio Level Manual Adjustment of the AudioManual Adjustments Recording Level Engaging the Manual Audio Recording Level Adjustment ModeWind CUT MIC2 Adjusting the Audio Recording Level ManuallyReducing the Wind Noise of the Microphone Wind CUT MIC1Camera menu screen Manual Adjustments Shake Compensation Function For details on the items, see Camera Menu Screen on Adjusting the QualityManual Adjustments Camera Image Items for settingFWD Playback ProcedurePlayback Playback of Tape Search Fast-Forward Playback/Rewind Playback Blank SearchFast-Forward, Rewind h Zoom lever Playback audio volume Playback Adjusting the Playback Sound VolumeAudio OUT connector Playback Outputting CH-3/CH-4 Channel Sound SettingSetting  Confirm that the Mode switch is set to VTRVC-VDV206 4P-6P GY-DV300 cannot be used as the recording componentDV cable VC-VDV204 4P-4P B Y DV Mode Screen for presetting time codeScreen for setting date and time ManualGY-DV301 only Display 2/2 menu screen System menu screenButton CAM-B Menu Screen Setting Menu ScreensMenu Mode Cursor Indicates position of Mode switchSet value Menu Screen Contents of Menu Screens  System 1/2 screen Set Value Contents System Menu Screen Shooting modeMenu Screen Contents of Menu Screens cont’d VF+LCD OFF System Menu Screens VTR Playback modeNET Remote OFF Display Menu Screen  Display 1/2 Menu Screen Set Value Contents Display 2/2 Menu Screen Set Value Contents Display Menu Screen cont’d Auto Knee function Camera Menu ScreenCamera Menu Screen Cont’d Operation Menu Screen VTR Menu Screen CLOCK/TC Menu ScreenImproper operation and notices Indication Condition Remedy Troubleshooting Alarm Indications and ActionsIndication Condition Blinking Condition Remaining Battery/Tape Tally lamp Symptoms Troubles, Checks and Remedial Actions Troubleshooting In Case of DifficultyOr CAM-B. GY-DV301 only Is the Mode switch set to VTR?Playback button is pressed Menu Button ModeSet the Power switch to on Set the Mode switch to VTR Others Displaying the Hour Meter DisplayOthers If dirt penetrates into the interior of viewfinder  Y/C cable Others Installing the ferrite core DC cable  Earphone cableOthers Specifications  General Others Specifications cont’d Accessories  Optional Accessories109  External Dimensions unit mm130

GY-DV301, GY-DV300 specifications

The JVC GY-DV300 and GY-DV301 are part of JVC's renowned D-Series of professional camcorders, known for their impressive video quality and user-friendly features. Launched in the early 2000s, these models gained widespread recognition for their reliability and versatility in various broadcasting and filmmaking environments.

Both camcorders utilize a 1/3-inch CCD sensor that delivers high-quality images with a resolution of up to 720 x 480 pixels in standard definition. The GY-DV300 is particularly notable for its innovative pixel shift technology, which enhances image resolution and detail by shifting the sensor pixels to improve clarity and reduce artifacts. This feature is especially beneficial for capturing finer details in dynamic scenes, making it suitable for both documentary filmmaking and news reporting.

One of the standout features of the GY-DV301 is its advanced lens system, which provides a 16x optical zoom with a focal length range that allows for excellent versatility in framing shots. The Fujinon lens used in these models is well-regarded for its superior optical performance, ensuring crisp, vibrant images in various lighting conditions. Additionally, both camcorders come equipped with a built-in ND (neutral density) filter, enabling filmmakers to control light exposure creatively without compromising on depth of field.

The user interface of the GY-DV300 and GY-DV301 is designed with professionals in mind. The camcorders offer manual controls for focus, iris, and white balance, allowing users to have precise control over their shooting parameters. The ergonomic design ensures that the camcorders are comfortable to use over extended periods, with a range of customizable buttons and settings readily accessible.

In terms of recording formats, the GY-DV300 and GY-DV301 support DV format recording, which offers high-quality digital video suitable for editing and broadcast. They also feature multiple connectivity options, including FireWire and composite outputs, making them compatible with a wide array of editing systems and broadcasting equipment.

Overall, the JVC GY-DV300 and GY-DV301 represent a significant step forward in video technology during their time, merging advanced imaging capabilities with robust professional features. Their blend of quality, flexibility, and an intuitive operational design has made them enduring choices for videographers and broadcasters alike, solidifying JVC's reputation in the professional video market.