JVC GY-DV5100 instruction manual Reproducing Time Codes, Regen

U

E

10. TIME CODE OPERATION

10-3Recording Time Codes in Continuation of Time Codes Recorded on Tape

The GY-DV5100 also incorporates a time code reader. Therefore, when the unit enters record mode from record-standby mode, it can read the time code data recorded on the tape and record time codes in continuation of the existing data. The recorded user’s bit data are identical to the user’s bit data recorded on tape.

●However, approximately ±1-frame variations may occur in scene accuracy.

To enable this function, set the time code related switches as follows before starting recording.

					Setting
					■ Set the TC GENE switch inside the cover on the side to
					REGEN.
		LCD BRIGHT		DISPLAY	● The time code framing mode automatically becomes the
				COUNTER	mode (drop frame or non drop frame) already recorded on
CH-1 AUDIO	CH-2	CH-1	FRONT		the tape.
			CH-2
			REAR
LEVEL			AUDIO IN
FRONT MIC +48V		AUDIO SELECT		TC GENE.
		CH-1	CH-2
ON	OFF		AUTO
			MANUAL

TC GENE switch

10-4 Reproducing Time Codes

The GY-DV5100 incorporates a time code reader. During playback, the time code or user’s bit data recorded on the tape is displayed on the LCD monitor or in the viewfinder. (Status screen)

10. TIME CODE OPERATION

10-3Recording Time Codes in Continuation of Time Codes Recorded on Tape

The GY-DV5100 also incorporates a time code reader. Therefore, when the unit enters record mode from record-standby mode, it can read the time code data recorded on the tape and record time codes in continuation of the existing data. The recorded user’s bit data are identical to the user’s bit data recorded on tape.

●However, approximately ±1-frame variations may occur in scene accuracy.

To enable this function, set the time code related switches as follows before starting recording.

Setting

■ Set the TC GENE switch inside the cover on the side to

REGEN.

LCD BRIGHT DISPLAY

COUNTER

				FRONT
				REAR
CH-1	AUDIO	CH-2	CH-1	CH-2
	LEVEL			AUDIO IN
FRONT MIC +48V			AUDIO SELECT		TC GENE.
			CH-1	CH-2
	ON	OFF		AUTO
				MANUAL

TC GENE switch

10-4 Reproducing Time Codes

The GY-DV5100 incorporates a time code reader. During playback, the time code or user’s bit data recorded on the tape is displayed on the LCD monitor or in the viewfinder. (Status screen)

Setting

Playback time code indication

☞ See “Displaying Time Code” on page 67.

Playback time code indication

Setting

☞See “Displaying Time Code” on page 67.

00:00:00:00

CAUTION:

A time code with a duration of more than 2 hours may not be displayed correctly by DV components for general consumer use, as some of these lack the capability to display longer time codes.

00:00:00:00

CAUTION:

A time code with a duration of more than 2 hours may not be displayed correctly by DV components for general consumer use, as some of these lack the capability to display longer time codes.

	12.2V
PLAY	01/02/03 01:23:45

	12.2V
PLAY	01/02/03 01:23:45

Status screen

Status screen

70 E-70