JVC LYT0201-001A manual Recording Mode Setting, SET Recording Mode, Select Dial

EN13

Recording Mode Setting

Set depending on your preference.

LCD monitor

Recording Menu

4	REC MODE	SP
	WIDE MODE	OFF
	ZOOM	40X
	DIS	ON
	GAIN UP	AGC

TO DATE / TIME MENU

TO SYSTEM MENU

END

4REC MODE	SP
WIDE MODE	OFF
ZOOM	40X
DIS	ON
GAIN UP	AGC

TO DATE / TIME MENU

TO SYSTEM MENU

END

Recording mode indicator

SP

Lock button

Power lamp

5S
M	OFF Y
A		P
		AL

Power dial

MENU button

Select Dial

SPLP

SELECT OPERATION MODE
1 Set the Power Dial to “	M	” while pressing down

the lock button located on the dial.

2 OPEN LCD MONITOR Open the LCD monitor fully.

The power lamp comes on and the camcorder is turned on.

•The LCD monitor turns on/off automatically when it is opened/closed at approx. 90 degrees while the Power Dial is set to any operation mode (except “OFF”).

•The LCD monitor can be tilted upward up to 180 degrees and downward up to 90 degrees.

3 ACCESS RECORDING MENU Press MENU. The Recording Menu appears.

4 SET RECORDING MODE

First move the pointer and highlight bar to “REC MODE” by rotating the Select Dial. Press the Select Dial and the parameter “SP” or “LP” is highlighted. Select “SP” or “LP” by rotating the Select Dial. Press the Select Dial twice to exit from the Recording Menu.

•“LP” (Long Play) is more economical, providing 1.5 times the recording time.

•Audio Dubbing is impossible on a tape recorded in the LP mode.

NOTES:

●If the recording mode is switched during recording, the playback picture will be blurred at the switching point.

●It is recommended that tapes recorded in the LP mode on this camcorder be played back on this camcorder.

●During playback of a tape recorded on another camcorder, blocks of noise may appear or there may be momentary pauses in the sound.