EN
21
Time Code
During recording, a time code is recorded on the tape. This code is to confirm the location of the recorded scene on the tape during playback.
If recording starts from a blank portion, the time code begins counting from “00:00:00” (minute:second:frame). If recording starts from the end of a previously recorded scene, the time code continues from the last time code number.
To perform Random Assemble Editing (☞ pg. 63), time code is necessary. If during recording a blank portion is recorded partway through the tape, the time code is interrupted. When recording is resumed, the time code starts counting up again from “00:00:00”. This means the camcorder may record the same time codes as those existing in a previously recorded scene. To prevent leaving a blank portion on a tape, perform the procedure in “Recording From The Middle of A Tape” (☞ pg. 20) in the following cases;
•After playing back the recorded tape, when you shoot again.
•When power shuts off during shooting. •When a tape is removed and
during shooting.
•When shooting using a partially recorded tape. •When shooting on a blank portion located
partway through the tape.
•When shooting again after already shooting a scene and opening/closing the cassette cover.
Display
TC 12 : 34 : 24
Time code is displayed during playback.
Minutes
Seconds
Frames
(25 frames = 1 second)
NOTES:
●The Time Code cannot be reset.
●During
When blank portion is recorded on a tape
Time code | Time code | Time code |
00:00:00 | 05:43:21 | 00:00:00 |
Tape
Already recorded scene
Blank
Newly recorded scene
Shooting start point Shooting stop point Shooting start point
Proper recording
Time code | Time code | Time code |
00:00:00 | 05:43:21 | 05:44:00 |
Tape
Already recorded scene
New scene
Latest scene
Shooting start point | Shooting start point | Shooting start point |