JVC LYT0201-001A manual Self-Timer, Engage SELF-TIMER Mode, Stop SELF-TIMER Recording

EN27

Self-Timer

Once the camcorder is set, the camcorder operator can become part of the scene in a more natural way adding the final touch to a memorable picture.

Display

START/STOP button

Lock button

Power lamp

				P
5S		Y	A	L
M	A	OFF

MANUAL

– – –

PAUSE

Self-Timer indication

After 15 sec.

	Power Dial		MANUAL		REC
					444
When the START/STOP button
is pressed, the tally lamp
			During recording
changes as shown below:
Begins blinking		´ Blinks quickly		´ Stops blinking
(Self-Timer starts)		(Self-Timer shooting			and stays on
		starts soon)			(Self-Timer
				4	shooting starts)

After approx. 15 sec.

1 SELECT OPERATION MODE

Turn the Power Dial to “ ” while pressing down the lock button located on the dial.

2 PULL OUT VIEWFINDER OR OPEN LCD MONITOR

Pull out the viewfinder fully or open the LCD monitor to approx. 90 degrees. The Self-Timer indication appears.

•The camcorder enters the Record-Standby mode.

•You can tilt the LCD monitor upward to 180 degrees so that it faces forward and view yourself while self-recording (with the viewfinder pushed back).

3 ENGAGE SELF-TIMER MODE

Press START/STOP.

After 15 seconds, the beep sounds and recording begins.

4 STOP SELF-TIMER RECORDING

Press START/STOP.

•The camcorder re-enters Record-Standby mode.

5 END SELF-TIMER RECORDING

Set the Power Dial to the “ A ”, “ M ” or “OFF” position.

•When turning to “OFF”, it is not necessary to press down the lock button.

To Take A Snapshot In The Self-Timer Mode . . .

.... in step 3, press SNAPSHOT instead of

START/STOP. After 15 seconds, a 6-second still is recorded. After that, the camcorder enters the Record-Standby mode.