JVC 0597TOV*UN*SN manual Begin Automatic Editing, END Automatic Editing, Edited Tape VCR Stop

							EN 37
ORIGINAL TAPE (camcorder)						AUTOMATIC EDITING TO VCR
	1		3	2	OUT		ENGAGE VCR’S RECORD–PAUSE
		IN	OUT IN OUT	IN			MODE
							Point the remote control toward the VCR’s infrared
						1 sensor and press VCR REC STBY, or manually
							engage the VCR’s Record-Pause mode.

EDITED TAPE (VCR)

STOP

EDIT

BEGIN AUTOMATIC EDITING

2 Press EDIT on the camcorder, and the previously selected scenes are copied to the VCR in the specified order.

END AUTOMATIC EDITING

3 When all selected scenes have been copied, the camcorder and VCR enter the still or pause mode. Press STOP on both units.

•When finished editing, be sure to disconnect the editing cable and the audio/video cable.

NOTES:

● If you performed step 1 C on page 35 (“MAKE CONNECTIONS”), keep the remote control pointed at the VCR during editing.

● The on-screen display only appears while the camcorder searches for each scene.

● There may be noise at in- or out-points on the edited tape with certain VCRs.

SUPPLEMENTAL INFORMATION ON THE REMOTE CONTROL

Player (JVC VCR)		AV OUT
To	Editing cable
R.A. EDIT
	(provided)
		AV IN
	Recording deck
To
PAUSE IN
	RM-V704U or
	RM-V700U
	(provided)

Using the RM-V704U/V700U, it is also possible to perform deck-to-deck Random Assemble Editing. The playback deck must be an R.A. Edit-capable JVC VCR. The recording deck can be...

■a VCR other than JVC, or

■a JVC VCR which has neither a Remote PAUSE nor an R.A. EDIT connector

How to use:

—Connect the playback deck and RM-V704U/V700U as shown on the left.

—Set the RM-V704U/V700U to correspond to the brand of the recording deck. (☞ pg. 34)

—For Random Assemble Editing procedure, please refer to the instruction manual of the JVC VCR you are using as the playback deck.

Notes:

■RM-V704U/V700U cannot be used to control the playback deck.

■RM-V704U/V700U is capable of controling basic operations of the recording deck. While pressing VCR CTL, press PLAY, STOP, PAUSE, FF or REW for these functions. (Not possible with some brands and models). Other buttons cannot be used.

■To put the recording deck in the Record-Pause mode, use the controls on the recording deck itself.