JVC GR-AX210 specifications Editin G

32

REW/FF CANCEL

IN/OUT

R.A. EDIT

PLAY/PAUSE

STOP

To EDIT

Editing cable (provided)

	To AUDIO and
	VIDEO out
Audio and Video	connector
cable (optional)
	To AUDIO and
If your TV/VCR has	VIDEO IN
	connectors
the SCART connector,
use the provided
cable adapter.

To		VCR (Recording deck)
Remote
PAUSE		A B
To Pause-In		C
RM-V704U			VCR REC STBY
(optional)
IN	OUT		IN	OUT
ç♣ 1 0:00:25		ç♣ 1	0:00:25	0:01:05
♣ 2		♣ 2	0:03:18	0:03:31
♣ 3		♣ 3	0:02:33	0:02:53
♣ 4		♣ 4	0:04:11
♣ 5		♣ 5
♣ 6		♣ 6
♣ 7		♣ 7
♣ 8		♣ 8
COUNTER	0:00:25	COUNTER		0:04:11
TOTAL	0:00:00	TOTAL		0:01:13

EDITING(cont.)

PREPARE CAMCORDER

2 Insert a recorded tape and set the power switch to PLAY.

PREPARE VCR

3 Turn the power on, insert a recordable tape and engage the AUX mode (refer to VCR’s instructions).

SELECT SCENES

ACCESS R.A. EDIT COUNTER DISPLAY

1 Press PLAY/PAUSE, then press R.A. EDIT and the counter display appears in the viewfinder and the screen of the connected TV.

REGISTER BEGINNING OF SCENE

2 Press REW or FF to locate the beginning of a scene you want, then press IN/OUT to register that point. The data appears under IN on the display.

REGISTER END OF SCENE

3 Press REW or FF to locate the end of the scene and press IN/OUT to register it. The data appears under OUT on the display. The total time of the registered scene(s) is displayed at the bottom of the screen.

REGISTER ADDITIONAL SCENES

4 Repeat steps 2 and 3 for each additional scene (as many as 8).

MAKE CORRECTIONS

5 Press CANCEL during steps 2 and 3 to erase the most recently registered point.

NOTES:

●There must be at least one second between an in-point and its corresponding out-point.

●The camcorder prerolls during R.A. Edit, so there must be at least 15 seconds of recording material prior to any in-point.

●Blank portions of tape cannot be registered as in-points or out-points.

●If it takes more than 5 minutes to search for an in-point, the VCR’s Record-Pause mode is cancelled and editing doesn’t take place.

●Pressing R.A.EDIT clears all in- and out-points from memory.

●Leave a small margin for error around each in-point to ensure the scene is recorded in its entirety.

GR-AX210EK-2 32

96.10.8, 1:25 PM