JVC GR-AX210 specifications Special Notes on Video Heads

Page 42

42CAUTIONS(cont.)

2. Avoid using the unit . . .

.... in places subject to excessive humidity or dust.

.... in places subject to soot or steam such as near a

cooking stove.

.... in places subject to excessive shock or

vibration.

.... near a television set.

.... near appliances generating strong magnetic or

electric fields (speakers, broadcasting antennas, etc.).

.... in places subject to extremely high (over 40°C)

or extremely low (under 0°C) temperatures.

3.DO NOT leave the unit . . .

.... in places of over 50°C.

.... in places where humidity is extremely low (below 35%) or extremely high (above 80%).

.... in direct sunlight.

.... in a closed car in summer.

.... near a heater.

4.To protect the unit, DO NOT . . .

.... allow it to become wet.

.... drop the unit or strike it against hard objects.

.... subject it to shock or excessive vibration during

transportation.

.... keep the lens directed at extremely bright

objects for long periods.

.... direct the eyepiece of the viewfinder at the sun.

.... carry it by holding the viewfinder.

.... swing it excessively when using the shoulder

strap.

5.This camcorder features a built-in head cleaner which automatically cleans the heads and head drum when a cassette is loaded or unloaded. If, however, the heads become dirty and cause blurriness or interruption in the playback picture, consult your nearest JVC dealer.

About moisture condensation . . .

You have observed that pouring a cold liquid into a glass will cause drops of water to form on the glass‘ outer surface. This same phenomenon occurs on the head drum of a camcorder when it is moved from a cool place to a warm place, after heating a cold room, under extremely humid conditions or in a place directly subjected to the cool air from an air conditioner.

Moisture on the head drum can cause severe damage to the video tape, and can lead to internal damage to the camcorder itself.

Serious malfunctioning

If malfunctioning occurs, stop using the unit immediately and consult your local JVC dealer.

SPECIAL NOTES ON VIDEO HEADS

Dust and dirt on video heads

1.Always allow enough time for your camcorder to acclimatize to its environment before using it.

2.Do not use the unit in areas of high humidity. (Typical areas of high humidity are given below.) •From being used or stored in a very cold

outdoor situation, then immediately being used in a warm indoor situation.

•From being used or stored in a cool air- conditioned situation, then being used in a high-humidity outdoor situation.

•Other areas where rapid large temperature changes can occur.

3.Taking care of your "C" format video cassette tapes..

•Store the video cassette tapes in a vertical position, complete in their cassette cases.

•During transportation, always store cassettes in their cassette cases.

4.Check recorded information at regular intervals.

If the camcorder is equipped with a quick review facility, use this facility to check whether the picture is clear or not.

If the quick review or playback picture is not clear, then the video heads may be dirty.

Note:

As a maladjusted tracking control can give similar symptoms to dirty video heads, please check that the tracking control of the unit is in the centre position.

Cleaning the video heads

Accumulation of dirt and other particles on the video heads may cause the playback picture to become blurred or interrupted. Although this camcorder is equipped with a built-in head cleaner which automatically cleans the heads, reducing the likelihood of dirty heads, if such troubles are encountered, we recommend the use of the cleaning cassette specifically designed for JVC camcorders, model number TCC-2U. Please use the cleaning cassette as indicated on the right:

1After inserting the cleaning cassette, activate the Play mode for a maximum of 15 seconds (normally, 5 seconds is sufficient).

2Remove the cleaning cassette and check the playback picture with a previously good- recorded tape.

3If the picture is clear, then recording on a new tape can begin when desired.

4If the picture is not clear, repeat steps 1 to 3 up to two more times.

5If the picture is still unclear, consult your local

JVC dealer.

Important Note:

If heads have become dirty, the associated tape will also be damaged, please do not use the tape again.

*A built-in head cleaner automatically cleans the video heads and head drum whenever a cassette is loaded and unloaded to reduce head clogging.

*Cleaning cassette TCC-2U is available from your JVC local dealer.

GR-AX210EK-2

42

96.10.8, 1:26 PM

Image 42
Contents GR-AX210 Dear Customer Connection to the mains supply in the United KingdomCrossed Out Dust Bin Mark Some DO’S and DON’TS on the Safe USE of Equipment Charger AA-V11EK BN-V12U Lithium Battery Cable adapter Ajor FeaturesAC Power Adapter Battery Pack Cassette Adapter C-P7U Zoom-inBATT. Release Using the battery packTo remove the battery pack Eject PushAttach Battery Pack PowerSupply Power Detach Battery PackTo AC outlet DC OUT terminal AC Power DC cord Charge markerAA-V11EK Clock Lithium Battery Removal/Insertion Date/Time SettingsGetting Started Viewfinder Adjustment Tape Length/Recording Mode SettingLoading/Unloading a Cassette Grip Adjustment Shoulder Strap AttachmentTripod Mounting RM-V20U Remote Control Unit To Remote Buttons FunctionsLoad a Cassette Enter RECORD-STANDBY ModeLens Cover Switch Power Start ShootingRetake Zoom indicator Zoom-inPower zoom switch START/STOP VissDial Viewfinder Mode Recording Advanced FeaturesViewfinder Mode ND EffectAdjust White Balance White Balance AdjustmentAdjust Focus White balance mode indicatorFader Cinema mode Engage Cinema ModeRestore Normal Screen CinemaRelease Focus Lock FocusingLock Focus F1 F2 Function SELRelease Manual Focus Mode ButtonRestore Initial Setting Exposure ControlDarken Image Select Display Choose Display ModeDate/Time Character Insert Connect Camcorder to MonitorSET Character or Title Access Character ModeCharacter Generator ScreenExample of Character Generator & Title Select Preset TitleInstant Titles Character GeneratorRecording Tally lamp Program AESTART/STOP Interval REC Time Release Animation Mode Check Your WorkPlay Back on Connected VCR Cassette AdapterInsert Cassette in Adapter Remove Cassette from AdapterConnect Camcorder to VCR Connect Camcorder to TVConnection To a VCR a Editing, Dubbing and Playback Playback PLAY/PAUSE Stop REW PowerPlayba CK Basic Playback Stop PlaybackTracking PLAY/PAUSE Counter R/M REW Stop Play Pause Playback FeaturesFeature PurposeStart Editing Random Assemble Editing R.A.EditFind EDIT-IN Point Stop Editing TemporarilyConnect to SET Remote to Operate VCROperate the VCR RM-V704U optionalEditin G END Automatic Editing Engage VCR’S RECORD-PAUSE ModeBegin Automatic Editing Player JVC VCRCounter R/M Power 01234Tape CounterREW Play Pause Audio DUB Insert Audio Dubbing Engage Audio DUB Standby ModeAudio dubbing indicator Viewfinder Mic Begin Audio DubbingCleaning The Camcorder After UseRecording does not start No power is suppliedReview or Retake mode Tape is running, but there’s no playback pictureIndex Controls ControlsIndex Viewfinder Auto Mode Lock Mode Ndex TermsTo avoid hazard To prevent damage and prolong service lifeFor safety, do not To prevent damage to the camcorderSpecial Notes on Video Heads Specifications GR-AX210