JVC GR-AX210 specifications Recording, Tally lamp Program AE, START/STOP Interval REC Time

96.10.8, 1:25 PM

”, 15S is automati-

NOTE:

If the PROGRAM AE dial is set to “ cally selected.

START DELAYED RECORDING

3 Press Recording Start/Stop. The tally lamp begins blinking, and the blinking speed increases about

5 seconds before recording starts. When recording begins, the lamp stops blinking but stays lit.

RELEASE SELF-TIMER MODE

4 To release when the tally lamp is not blinking, press INTERVAL continuously until “ ” disappears. To release when the tally lamp is blinking, press Recording Start/Stop to stop the blinking, then press INTERVAL continuously until “ ” disappears.

SET TIME DELAY

Make sure the lens cover is open, set the power switch to CAMERA.

1

2 On the RM-V20U, press INTERVAL to set the delay time. There are four choices, and they appear in the viewfinder in the following order (each time INTERVAL is pressed): 15S (15 seconds), 30S

(30 seconds), 1MIN (1 minute) and 5MIN

(5 minutes). Pressing again releases the Self-timer.

Self-Timer

You can set the delay between pressing Recording Start/ Stop and the actual start of recording. If you secure the camcorder, you (or whomever is operating the camcorder) can enter the scene before recording starts.

NOTE:

You need the optional RM-V20U remote control unit to perform this procedure.

ENGAGE RECORD–STANDBY MODE

Advanced Features

24RECORDING

Tally lamp PROGRAM AE

START/STOP

INTERVAL

REC TIME

RM-V20U (optional)

GR-AX210EK-2 24