JVC LYT0002-0N4B specifications Counter R/M Power, Tape Counter, Insert editing, Indicator

NOTES:

● When Insert Editing is performed with the LCD monitor fully opened, the original audio will be heard from the speaker.

● After step 5, Retake (☞ pg. 18) can be performed. ● The tape may stop slightly before or after the

designated end point, and noise bars may appear. Neither indicates a defect in the unit.

● Only video signal is recorded in the Insert Editing mode.

Press STOP.

7

5 Press and hold INSERT, and without releasing INSERT, press and release PAUSE. The Insert mode is engaged, and the scene the camcorder is aimed at appears on the screen.

BEGIN INSERT EDITING

6 Press START/STOP. When the counter reaches “0:00:00”, editing stops automatically and the camcorder enters the Insert-Pause mode.

END INSERT EDITING

RESET COUNTER

Play back the tape, locate the Edit-out point and press PAUSE on the camcorder or the remote control.

FIND EDIT-OUT POINT

Set the Power switch to “PLAY”.

1

2

3 Press and hold COUNTER R/M for more than

2 seconds to reset the tape counter, then press again for less than 1 second and make sure “M” appears in the LCD monitor or the viewfinder.

Insert Editing

You can record a new scene into a previously recorded tape, replacing a section of the original recording with minimal picture distortion at the in- and out-points. The original audio remains unchanged.

NOTE:

Use the RM-V704U or RM-V700U remote control unit to perform this procedure.

SELECT MODE

42EN USINGREMOTECONTROLUNIT (cont.)

COUNTER R/M

POWER

	M-1:23:45	Tape Counter
				FIND EDIT-IN POINT
		Insert editing
				Press REW to go a little beyond the beginning of the
		indicator
			4 scene you want to replace, press PLAY to view the
				recorded tape, and press PAUSE exactly at the Edit-
LCD monitor or				in point where the new scene should start.
viewfinder				ENGAGE INSERT EDITING MODE

START/STOP

REW

PLAY

PAUSE

INSERT

RM-V704U or RM-V700U (provided)