JVC GR-AX1010 manual Recording, Tally lamp, START/STOP INT. Time REC Time

CLOSE MAIN MENU

Press MENU.

START DELAYED RECORDING

Press RECORDING START/STOP. If you set the tally lamp to “ON” (☞ pg. 31), it begins blinking, and the blinking frequency increases about 5 seconds before recording is to start. Once recording begins, the lamp stops blinking but stays lit.

SET INTERVAL TIME

5 Press – to move the highlight bar down to “Interval

Timer”, press NEAR, then press + or – to cycle through the choices. Stop when the desired time appears. Choose from “15S”, “30S”, “1min”, “5min”, or select to turn the function “OFF”. Then press FAR twice to return to the Main Menu screen.

ACCESS SUB MENU SCREEN

Press MENU.

ACCESS MAIN MENU SCREEN

Set the Shooting Mode selector to “PRESET”.

SELECT MODE

Make sure the lens cover is open, then set the Power switch to “CAMERA”.

1

2

3

4 Press – to move the highlight bar down to “Sub Menu”, then press NEAR. The Sub Menu screen appears.

Self-Timer

You can set the delay between pressing RECORDING START/STOP and the actual start of recording. If you secure the camcorder, you (or whomever is operating the camcorder) can enter the scene before recording starts.

ENGAGE RECORD-STANDBY MODE

34

RECORDING

AdvancedFeatures(cont.)

			Interval Timer Indicator
Recording
				1min
Time Indicator				1 s
Shooting mode
selector
	+
	FAR	NEAR

MENU

–

Tally lamp

START/STOP

INT. TIME

REC TIME

RM-V706U (provided)

	Shift Zoom	OFF
	Tele Macro	OFF
	Gain Up	AGC
	Color Filter	NOR .
	Tape Length	T30
	Title
	Date/Time
	Sub Menu
Main Menu Screen
	Tally	ON
	Interval Timer	OFF
	Rec Time	OFF
	JLIP ID NO .	07

6

7

To Release Self-Timer . . .

.... while the tally lamp is blinking, press RECORDING

START/STOP to stop the blinking, then set “Interval Timer” to “OFF” or press INT. TIME on the remote control until “” disappears.

.... while the tally lamp is lit but not blinking, press set

“Interval Timer” to “OFF” or press INT. TIME on the remote control until “” disappears.

NOTE:

Instead of performing steps 2 – 6, you can set the interval time by pressing INT. TIME on the remote control.

Sub Menu Screen