Kenwood XD-550, XD-700, XD-750 Before applying power, Safety precautions, For the United Kingdom

Page 2

2Before applying power

 

Units are designed for operation as follows.

 

Europe and U.K

AC 230 V only

 

For the United Kingdom

 

 

 

Factory fitted moulded mains plug

 

1.The mains plug contains a fuse. For replacement, use only a 13-

 

Amp ASTA-approved (BS1362) fuse.

 

2.The fuse cover must be refitted when replacing the fuse in the

 

moulded plug.

 

 

3.Do not cut off the mains plug from this equipment. If the plug

 

fitted is not suitable for the power points in your home or the ca-

 

ble is too short to reach a power point, then obtain an appropriate

 

safety approved extension lead or adapter, or consult your dealer.

 

If nonetheless the mains plug is cut off, remove the fuse and dis-

section

pose of the plug immediately, to avoid a possible shock hazard by

inadvertent connection to the mains supply.

 

Preparation

IMPORTANT: The wires in the mains lead are coloured in accord-

Brown

: Live

 

ance with the following code:

 

Blue

: Neutral

Do not connect those leads to the earth terminal of a three-pin plug.

Caution : Read this page carefully to ensure safe operation.

XD-750/700/550/500 (En)

Application section

Safety precautions

WARNING : TO PREVENT FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.

 

 

 

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER

 

CAUTION

 

 

 

 

(OR BACK). NO USER-SERVICEABLE PARTS INSIDE, REFER SERVICING TO QUALI-

 

RISK OF ELECTRIC SHOCK

 

 

 

FIED SERVICE PERSONNEL.

 

DO NOT OPEN

 

 

 

 

 

THE LIGHTNING FLASH WITH ARROWHEAD SYMBOL, WITHIN AN EQUILATERAL TRIANGLE, IS INTENDED

TO ALERT THE USER TO THE PRESENCE OF UNINSULATED “DANGEROUS VOLTAGE” WITHIN THE

PRODUCT’S ENCLOSURE THAT MAY BE OF SUFFICIENT MAGNITUDE TO CONSTITUTE A RISK OF ELEC-

TRIC SHOCK TO PERSONS.

THE EXCLAMATION POINT WITHIN AN EQUILATERAL TRIANGLE IS INTENDED TO ALERT THE USER TO

THE PRESENCE OF IMPORTANT OPERATING AND MAINTENANCE (SERVICING) INSTRUCTIONS IN THE

LITERATURE ACCOMPANYING THE APPLIANCE.

Knowledge sections

REQUIREMENT BY NEDERLAND GAZETTE

Batteries are supplied with this product. When they empty, you should not throw away. Instead, hand them in as small chemical waste.

The marking of products using lasers

(Except for some areas)

CLASS 1

LASER PRODUCT

The marking is located on the rear panel and says that the compo- nent uses laser beams that have been classified as Class 1. It means that the unit is utilizing laser beams that are of a weaker class. There is no danger of hazardous radiation outside the unit.

Page 1 Page 3
Image 2
Page 1 Page 3
Contents XD-750 XD-700 XD-550 XD-500 Marking of products using lasers Except for some areas Before applying powerSafety precautions For the United KingdomApplication section ContentsBasic section Special features Discs which can be played with this unit Disc handling precautionsHandling of discs and tapes System connection 1Locate the position providing good reception condition FM indoor antennaSpeaker left 2Fix the antennaMonitor TV Regard to the Surround switchSurround rear speakers RS-N700/N750 FM outdoor antenna Antenna adapter OptionalControls and indicators Main UnitCD player unit ReceiverCassette deck unit 1ON/STANDBYRunning Indicator DisplayRemote control Unit Operation Operation of remote control unitLoading batteries Remove the cover Insert batteries Close the coverPreparation section Lets put out some sound Switching the power on OFFVolume adjustment Basic use methodAuto Power Save function Muting the sound temporarily Remote control unit onlyListening through headphones Standby mode of ON/STANDBY switchStart playback Playback of CDLoad a disc Time display on the CD playerTo pause playback Skipping tracksPlayback from desired track To stop playbackSelect the deck to be used for playback Start playback Playback of tapeLoad a cassette tape To wind tape at high speed Selection of reverse modeTransport direction indicators Selection of Dolby NR Noise ReductionRelay play Tip for use of the tape counterSearching for the desired music program Dpss Select a station Receiving broadcast stationSelect the broadcast band Select the tuning mode Collective presetting of stations auto presetOne-by-one presetting manual preset M 8 MHzLets record Start recording Selection of the reverse modeSelect the source to be recorded 1 3 62 8Beat cancel function Points in CD recordingTo stop dubbing P ECopying tape Tape dubbing Stop playback Start dubbing2 P- 2 Playback of CDListening in the desired sequence program playback To quit the program mode To add a track to the programTo repeat all discs Repeated playbackTo repeat a disc To stop repeated playbackTo repeat only one track To repeat only the programmed tracksTo cancel random playback Confirm that the PGM indicator is not litSelect the Random mode C 1 FM To switch the display contentsS. Radio Data System 1 2 MHz2Select the desired program type Select the PTY search modeW s To change to a different program type When a station is receivedStart the search Repeat steps 1, 2M 9 . MHz Auto preset the stationsMHz Select the desired informationTP Traffic Program indicator Wait for the desired informationRecording only desired titles Convenient CD recordingSelection of the convenient CD recording type One touch recording of an entire CDEnter the recording length of the tape Select the Edit modeSelect the disc Start edit recordingPlay a CD 3 13 2 5 8 To end recording in the middlePress the O.T.E. key 1 6 2 81Select the disc 1Select the discStart recording 1 5Insert the discs 4Replace the discs as requiredSelect what to adjust Effective Sound AdjustmentAdjustment of balance and input level AdjustDemonstration Selecting an equalizer patternC K DemoW + 8 Adjust the equalizer patternCreation and memorizing of an equalizer pattern Display Manual or make sure it is already displayedV E L + 1 Enjoying Sound Field EffectsSource Direct for making the sound purer XD-550/XD-500 only Play the music Sing along with the accompaniment Enjoying KaraokeConnect a microphone Turn the MIC MIX. control fully CounterclockwiseEnter the figure of hour Clock adjustmentActivate the clock adjustment mode 3Enter the figure of minuteOperate easy To use Timer Operate easy To use Timer O.T.T Timer operationSleep timer Sleep To cancelSet the Power switch to OFF Standby position Timer programmingAdjust the listening volume Make preparations for the play recording6Enter the OFF time Select the timer program No. to be used5Enter the on time Make the desired reservationTo set the same timer program again Check the reservation contentWhen timer operation is not required To change the reserved contentsMemory backup function MaintenanceMaintenance of the set Regardto contact cleaner ReferenceSymptom Cause Remedy Operation to resetRemote control unit Case of difficultyCassette deck Sound skips CD playerBe played Speakers LS-N550/N500 Main unit RXD-750/700/550/500Speakers LS-N750/N700 For your records
Top Page Image Contents