Kenwood XD-700 Case of difficulty, Operation to reset, Remote control unit, Receiver, speakers

Page 56

5 6 In case of difficulty

XD-750/700/550/500 (En)

What seems to be a malfunction is not always so. Before calling for service, check the following table according to the symptom of your trouble.

Operation to reset

The microcomputer may fall into malfunction (impossibility to operate, erroneous display, etc.) when the power cord is un- plugged while power is ON or due to an external factor. In this case, execute the following procedure to reset the microcom- puter and return it to normal condition.

÷Please note that resetting the microcomputer clears the contents stored in and returns and to condition when it left the factory.

Reset using a sharp-tipped object.

RESET

°￿

Preparation section

Remote control unit

Symptom

Cause

Remedy

 

Remote control operation is not possible.

÷ Batteries are exhausted.

÷ Replace with new batteries.

$

 

÷ The remote control is too far away from the

÷ Operate the unit inside the remote control-

$

 

system, the controlling angle is deviated or

lable range.

 

 

there is an obstacle in between.

 

 

 

÷ There is no tape or CD set in the component

÷ Set a tape or CD in the component to be

 

 

to be played.

played.

 

 

÷ An attempt is made to play the cassette

÷ Wait until the recording ends.

 

 

deck which is recording something.

 

 

 

 

 

 

Application section

Knowledge sections

Receiver, speakers

Symptom

Cause

Remedy

 

Sound is not produced.

÷ The speaker cords are disconnected.

÷ Connect properly referring to “System con-

6

 

 

nection”.

^

 

÷ The volume control is set to the minimum

÷ Adjust to an required volume.

 

position.

 

&

 

÷ The MUTE switch of remote control unit is

÷ Switch MUTE OFF.

 

switched ON.

 

&

 

÷ The headphone plug is inserted into the

÷ Unplug the headphone plug.

 

jack.

 

 

 

 

 

 

The character display blinks and sound is

÷ The speaker cords are short-circuited.

÷ Turn the power OFF, remove the short-

6

not produced.

 

circuit and turn the power ON again.

 

 

 

 

 

Sound is not produced from the left or

÷ The speaker cords are disconnected.

÷ Connect properly referring to “System con-

6

right speakers.

 

nection”.

 

 

 

 

 

The clock display blinks without chang-

÷ There was a power failure.

÷ Adjust the present time again.

p

ing the figures.

÷ The power cord was unplugged from the

÷ Adjust the present time again.

p

 

outlet.

 

 

 

 

 

 

Timer operation is not possible.

÷ The present time has not been adjusted or

÷ Adjust the present time referring to “Clock

p

 

there was a power failure.

adjustment”.

W

 

÷ The timer ON time and OFF time have not

÷ Set the timer ON time and OFF time.

 

been set.

÷ Execute the timer program with the SRS E

 

÷ The timer execution was not set up.

 

 

3D (SOURCE DIRECT)* key.

 

 

 

 

 

Radio stations cannot be received.

÷ The antennas have not been connected.

÷ Connect antennas.

6

 

÷ A proper broadcasting band has not been

÷ Select a band.

¢

 

selected.

 

¢

 

÷ The frequency of the station to be received

÷ Tune to the frequency of the desired sta-

 

is not tuned.

tion.

 

 

 

 

 

Noise interferes.

÷ Car ignition noise.

÷ Install the outdoor antenna in an apart posi-

9

 

 

tion from the road.

 

 

÷ Influence of an electric appliance.

÷ Switch the suspected electric appliance

 

 

 

OFF.

 

 

÷ A TV set is installed near the system.

÷ Install the TV or the system at an increased

 

 

 

distance between them.

 

 

 

 

 

* The key inside ( ) is used only with the XD-550/XD-500.

Page 55 Page 57
Image 56
Page 55 Page 57
Contents XD-750 XD-700 XD-550 XD-500 Before applying power Safety precautionsMarking of products using lasers Except for some areas For the United KingdomApplication section ContentsBasic section Special features Discs which can be played with this unit Disc handling precautionsHandling of discs and tapes System connection FM indoor antenna Speaker left1Locate the position providing good reception condition 2Fix the antennaMonitor TV Regard to the Surround switchSurround rear speakers RS-N700/N750 FM outdoor antenna Antenna adapter OptionalControls and indicators Main UnitReceiver Cassette deck unitCD player unit 1ON/STANDBYRunning Indicator DisplayRemote control Unit Operation of remote control unit Loading batteriesOperation Remove the cover Insert batteries Close the coverPreparation section Switching the power on OFF Volume adjustmentLets put out some sound Basic use methodMuting the sound temporarily Remote control unit only Listening through headphonesAuto Power Save function Standby mode of ON/STANDBY switchPlayback of CD Load a discStart playback Time display on the CD playerSkipping tracks Playback from desired trackTo pause playback To stop playbackSelect the deck to be used for playback Start playback Playback of tapeLoad a cassette tape Selection of reverse mode Transport direction indicatorsTo wind tape at high speed Selection of Dolby NR Noise ReductionRelay play Tip for use of the tape counterSearching for the desired music program Dpss Select a station Receiving broadcast stationSelect the broadcast band Collective presetting of stations auto preset One-by-one presetting manual presetSelect the tuning mode M 8 MHzLets record Selection of the reverse mode Select the source to be recordedStart recording 1 3 62 8Beat cancel function Points in CD recordingP E Copying tape Tape dubbingTo stop dubbing Stop playback Start dubbing2 P- 2 Playback of CDListening in the desired sequence program playback To quit the program mode To add a track to the programRepeated playback To repeat a discTo repeat all discs To stop repeated playbackTo repeat only one track To repeat only the programmed tracksTo cancel random playback Confirm that the PGM indicator is not litSelect the Random mode To switch the display contents S. Radio Data SystemC 1 FM 1 2 MHz2Select the desired program type Select the PTY search modeW s When a station is received Start the searchTo change to a different program type Repeat steps 1, 2Auto preset the stations MHzM 9 . MHz Select the desired informationTP Traffic Program indicator Wait for the desired informationConvenient CD recording Selection of the convenient CD recording typeRecording only desired titles One touch recording of an entire CDSelect the Edit mode Select the discEnter the recording length of the tape Start edit recording3 1 3 2 5 8Play a CD To end recording in the middle1 6 2 8 1Select the discPress the O.T.E. key 1Select the disc1 5 Insert the discsStart recording 4Replace the discs as requiredEffective Sound Adjustment Adjustment of balance and input levelSelect what to adjust AdjustSelecting an equalizer pattern C KDemonstration DemoAdjust the equalizer pattern Creation and memorizing of an equalizer patternW + 8 Display Manual or make sure it is already displayedV E L + 1 Enjoying Sound Field EffectsSource Direct for making the sound purer XD-550/XD-500 only Enjoying Karaoke Connect a microphonePlay the music Sing along with the accompaniment Turn the MIC MIX. control fully CounterclockwiseClock adjustment Activate the clock adjustment modeEnter the figure of hour 3Enter the figure of minuteTimer operation Sleep timer SleepOperate easy To use Timer Operate easy To use Timer O.T.T To cancelTimer programming Adjust the listening volumeSet the Power switch to OFF Standby position Make preparations for the play recordingSelect the timer program No. to be used 5Enter the on time6Enter the OFF time Make the desired reservationCheck the reservation content When timer operation is not requiredTo set the same timer program again To change the reserved contentsMaintenance Maintenance of the set Regardto contact cleanerMemory backup function ReferenceOperation to reset Remote control unitSymptom Cause Remedy Case of difficultyCassette deck Sound skips CD playerBe played Speakers LS-N550/N500 Main unit RXD-750/700/550/500Speakers LS-N750/N700 For your records
Top Page Image Contents