EN 69
Changing
Remote Control
Code
This Remote is capable of transmitting two control codes; one set to respond to A code control signals and another set to respond to B code control signals.
This Remote control is preset to send A code signals because your VCR is initially set to respond to A code signals. You can easily modify your VCR and the Remote to respond to B code signals.
When using two JVC VCRs, set two VCRs and their Remotes to different codes, so that you can operate these VCRs separately.
2
VCR TV CABLE/DBS
1 2
4
7 8
0
5
3
9
1 Set remote operation mode
Set the VCR/TV/CABLE/DBS selector to “VCR”.
2 Set remote control code for Remote
1 Press and hold A/B.
2 Press the Number key “2”.
3 Press STOP ( 7 ), and release A/B.
3 Turn off VCR
Press POWER on the VCR.
4Check remote control code for VCR
Press PLAY (3) on the VCR for more than 5 seconds.
●The code currently set appears on the front display panel.
5 Turn on VCR
Press POWER on the Remote.
●The code transmitted from the Remote blinks for a few seconds on the front display panel.
●After the code disappears on the front display panel, make sure that the VCR is turned on by pressing POWER on the Remote.
●To set the Remote and the VCR back to A code control signals, repeat the same procedure as shown above except pressing the Number key “1” in step 2.
NOTE:
When "POWER SAVE MODE" is set to "ON" , you can not change the remote control code. Before changing the code, set "POWER SAVE MODE" to "OFF" (☞ pg. 56).
To control two VCRs with the same Remote
You can control two JVC VCRs by switching the remote control code for the Remote between A and B
(☞Ê stepÊ2), keeping two VCRs to different control codes.
●Press the Number key “1” for A code control signals and the Number key “2” for B code control signals. (To change only the remote control code for the Remote, DO NOT perform steps 3 to 5.)
(Ex.) To set Remote to B code:
A/B | 2 | STOP | Release |
| |||
|
| ||
| ABC |
|
Hold | Press in succession |
down |
|