Panasonic DMCFZ1000 owner manual Operate the manual ring to set the focus

Recording Modes

3

4

5

Press 2 ( ).

Press 3/4/2/1 to determine the area to be enlarged, and press [MENU/SET].

•The assist screen is displayed, enlarging the area. (MF Assist)

•If you press [DISP.], the area to be enlarged will be reset to the center.

Operate the manual ring to set the focus.

Rotate to A side:

Focuses on nearby subject

Rotate to B side:

Focuses on faraway subject

AIndicator for ¶ (infinity)

BMF Assist (enlarged screen) C Peaking

D MF Guide

• The in-focus portions will be highlighted. (Peaking)

• You can check whether the point of focus is to the near side or to the far side. (MF Guide)

A

B

B

A C D

∫Displaying the MF Assist

•It is displayed by rotating the manual ring.

•It can also be displayed by pressing 2 to display the setup screen for the enlarged area, deciding the area to enlarge using the cursor button, and then pressing [MENU/SET].

∫Changing the display of the MF Assist

Each time the rear dial is pressed, an enlarged display switches between a windowed screen display and a full screen display.

•If the rear dial is rotated, the display can be enlarged/reduced up to approximately 3 to 6 times when the enlarged display is in a windowed display or up to approximately 3 to 10 times when the enlarged display is in a full screen display.

∫Closing the MF Assist

•It will close when the shutter button is pressed halfway.

•You can also close MF Assist by pressing [MENU/SET].

•If you have displayed the MF Assist by rotating the manual ring, it will close approximately 10 seconds after you stop operating the camera.

42 SQT0196 (ENG)