Panasonic WV-CL924, WV-CL920 operating instructions Focus or FLANGE-BACK Adjustment

Page 13

FOCUS OR FLANGE-BACK ADJUSTMENT

The following adjustment should be made by qualified service personnel or system installers.

1. Loosen the screw on the side of the camera.

3.Tighten the screws on the side of the camera.

Caution: Tightening the screw by force will cause

damage to the screw or deviation of focus.

Flange-back

Adjusting Ring

Screw

2.Turn the flange-back adjusting ring to the desired position.

Note: Adjusting a focus in the visible rays may be soft-focused with the near-infrared light.

-13-

Image 13

Contents WV-CL924 Bol, within an equilateral triangle, is Contents Preface FeaturesClean the CCD faceplate with care PrecautionsDo not attempt to disassemble the camera Handle the camera with careWV-CL924 Major Operating Controls and Their FunctionsFlange-back Adjusting Ring FB Auto Iris Lens Connector0Gen-lock Termination Switch Hi-Z, G/L 75Ω 1Gen-lock Input Connector GEN-LOCK4AC/DC Compatible Input Terminal DC 12V IN/AC 24V 3Power Cord SocketWV-CL920 120 V AC 60Hz ConnectionsWV-CL924 12 V DC/24 V AC Recommended wire gauge sizes for 24 V AC line AC Power SupplyInstallation of Auto Iris Lens Connector Mounting the Lens Focus or FLANGE-BACK Adjustment Mounting from the top Installation of CameraCamera Setup Menu SetupATW1 ATW2 AWC Press and hold down for 2 seconds or more Opening the Setup MenuAll Reset Operation Setup OperationImportant Notice Editing the CAM SET UP MenuCamera Identification Camera ID Setting Setting ProceduresTo edit the Camera ID To enter a blank space in the Camera IDTo erase all characters in the editing area Light Control Setting ALC/ELCTo determine the display position of the Camera ID Back Light Compensation Back Light Comp ALC Mode with Preset onALC Mode with Preset OFF Blinking Gain Control Setting AGC ON/OFF Shutter Speed Setting ShutterElectronic Sensitivity Enhancement Sens UP Important Notices Synchronization Setting SyncVBS Gen-lock Mode Extvbs Page Line-lock Sync Mode LL VS Gen-lock Mode ExtvsPhase Coarse Auto-Tracing White Balance Mode ATW White Balance Setting White BALATW1 Auto Tracing White Balance Select AWC → Manual Fine Adjustment for AWC ATWMotion Detector Setting Motion DET Lens Drive Lens Drive Signal SelectionSpecial Menu Special Burst BW Prevention of Blooming and Smear To reset to the factory settingsAGC SpecificationsPage Standard Accessories Optional Accessories Panasonic Canada Inc