Before Use
1Pull the end of the Shoulder Strap through the Shoulder Strap Holder (49) on the
Palmcorder.
(49)
2 Fold the end of the Shoulder Strap, run it through the Shoulder Strap Length Adjuster, and pull it.
≥Pull it out more than 1 inch (2 cm) 1 from the Shoulder Strap Length Adjuster so that it cannot slip off.
1
≥Attach the other end of the Shoulder Strap to the other Shoulder Strap Holder in the same way.
Inserting a Cassette
1Slide the [OPEN/EJECT] Lever (41) toward the front and pull down to open the Cassette Compartment Cover.
(41)
OPEN /
EJECT
2Insert a Cassette.
3Close the Cassette Holder by pressing the [PUSH] mark 1.
1
PUSH
4Close the Cassette Compartment Cover.
ªAccidental Erasure Prevention
Opening the accidental erasure prevention slider 1 on the cassette (by sliding it to the [SAVE]
arrow direction) prevents recording. To enable
recording, close the accidental erasure prevention slider (by sliding it to the [REC] arrow direction).
1
R E C
SAVE
≥For other notes concerning this item, see
Using a Memory Card
A Card can be used to record pictures. ≥Use a genuine SD Memory Card or
MultiMediaCard manufactured by Panasonic only.
Before inserting or removing a Card, be sure to turn off the Palmcorder.
≥Otherwise, the Palmcorder may not function properly or it may cause the loss of recorded data in a Card.
ªInserting a Card
1Slide the [OPEN] Lever (3) to open the Card Slot Cover (5).
OPEN
(3)(5)
2While holding the Memory Card with its cut corner facing right 1, insert it into the Card Slot (4).
(4)
1
3Close the Card Slot Cover (5) securely.
Removing the Card
Open the Card Slot Cover and press the center of the Card and then pull it straight out.
≥After removing the Card, close the Card Slot Cover.
≥The Palmcorder may be damaged if the Card is forced out when the Card is fully inserted.
ªCard Access Lamp (17)
(17)
While the Palmcorder is accessing the Card (reading, recording, playback or erasing), the Card Access Lamp lights up.