![](/images/new-backgrounds/1141004/14100447x1.webp)
Before Using
Setting Date and Time
Since the internal clock of the Camcorder has a slight imprecision make sure to check the time before recording.
30
34
35
• Set to Tape/Card Recording Mode.
1 | Set [ BASIC] >> [ | CLOCK SET] >> [YES]. | |
| CLOCK SET | ||
| JAN /01/2005 | 12AM:00 | |
| SETUP |
| |
| SET | ENTER | EXIT |
2 | Move the Joystick Control [Ż] or [Ź] 35 | ||
| to select the item to be set. Then move the |
Joystick Control [Ÿ] or [ź] 35 to set the desired value.
•Year will cycle in the order shown below. 2000, 2001, ..., 2089, 2000, ...
3 Press the Joystick Control 35 to finish setting the date and time.
•The clock operation starts from [00] second.
•If the ] Indication flashes. In this case, charge the
•The clock uses the
About date/time
•The Date and Time function are driven by a
•Make sure to check the time before recording because the
Internal Lithium Battery Recharge
The internal lithium battery sustains the operation of the clock. If the [ ] or
1 Connect the AC Adaptor to the Camcorder with the power turned off and then connect to the AC jack.
•After charging for 4 hours, the
•Leave the Camcorder as is for approx. 24 hours, and the battery will drive the Date and Time for approx. 6 months. (Even if the [OFF/ON] Switch is set to [OFF], the battery is still being recharged.)
LP Mode
You can switch the tape recording speed.
• Set to Tape Recording/Playback Mode. Set [ BASIC] or [ ADVANCE] >> [ REC SPEED] >> [LP].
If the LP mode is selected, the recording time will be 1.5 times the SP mode, but some functions will be disabled.
•We recommend using the SP mode for important recordings.
•In order to fully exhibit the performances of the LP mode, we recommend using Panasonic cassettes marked LP mode.
•Audio dubbing is not possible with LP Mode. (p. 41)
•In the LP mode, the picture quality will not be degraded in comparison with the SP mode, but mosaic noise may appear on the playback image or some functions may be disabled.
-Playback on other digital video equipment or on digital video equipment without the LP mode
-Playback of the image on other digital video equipment recorded in the LP mode
-Slow Motion/Still Advance playback
Audio Recording Mode
You can select the sound quality of the recorded sound.
• Set to Tape Recording Mode.
Set [ SETUP] >> [ AUDIO REC] >> [12bit] or [16bit].
High
24 | For assistance, please call : |
|