![](/images/new-backgrounds/1295783/295783109x1.webp)
Others
INCORRECT OPERATION:
The Recording Start/Stop Button was pressed without connecting the USB cable to the PC in Picture Playback Mode.
CANNOT USE USB
CHANGE MODE:
The USB cable is connected to the Camcorder in Card Recording Mode or Picture Playback Mode.
CANNOT OPERATE:
You are attempting to record pictures on a Card while connecting the USB cable to the Camcorder in Tape Recording/Playback Mode.
UNABLE TO WRITE (MULTI RECORDING):
The [PHOTO SHOT] Button is pressed when you are recording pictures on a Tape while setting the Digital Effect [MULTI] of [EFFECT1].
UNABLE TO INSERT TITLE:
You are attempting to perform Title In Function when RapidFire Consecutive Photoshot Function is set.
CASSETTE DOOR OPENED:
Close the Cassette Compartment Cover before recording.
NO TITLE:
Titles are not recorded.
UNABLE TO WRITE (WIDE MODE):
You are attempting to record pictures of S1 signal (with aspect ratio 16:9) by pressing the [PHOTO SHOT] Button.
FILE LOCKED:
You are attempting to erase protected files.
CARD LOCKED:
The write protection switch on the SD Memory Card is set to [LOCK].
DISCONNECT USB CABLE:
You are attempting to turn the Mode Dial or turn the Camcorder off in PC Mode while connecting the USB cable to the Camcorder.
Notes and Hints
Concerning the Power Supply
•When the Camcorder has been used for a long time, the Camera body becomes warm, but this is not a malfunction.
•If the [CHARGE] Lamp does not light up although the Battery is attached to the AC Adaptor, detach the Battery and reattach it.
Inserting/Removing the Cassette
•In the case of using a previously recorded Cassette, you can use the Blank Search Function (p. 22)
to find the position where you want to continue recording.
•If a new Cassette is inserted, rewind to the beginning of the tape before starting recording.
•When inserting the cassette, make sure it faces in the right direction and then push it in until it stops.
•When the Cassette Holder is in action, do not touch anything except the [PUSH] mark.
Alarm Sounds
When [BEEP SOUND] on the [INITIAL]
1Beep
•When you start recording
•When you switch the [OFF/ON] Switch from [OFF] to [ON]
2Beeps
•When you pause recording
2 Beeps 4 times
•If you perform a wrong operation before or during recording.
Recording Check
•For Recording Check, the recording speed mode (SP/LP) must be the same as the mode used for the recording. If different, playback images will be distorted.
Recording on a Card
•Even if the [SHTR EFFECT] is set to [ON], the Shutter Effect cannot be recorded on the picture.
•When the color of the screen changes or blurs, adjust the shutter speed manually to 1/60 or 1/100.
Photoshot
•Photoshot Recording results in slightly inferior image quality.
RapidFire Consecutive Photoshot
•One more still picture may be recorded after you release the [PHOTO SHOT] Button.
•The RapidFire Consecutive Photoshot and Title Function cannot be used simultaneously.
•When the [SELF TIMER] is set to [ON], the Camcorder records the maximum number of recordable pictures depending on the [BURST MODE] setting.
•When using a card formatted by other equipment, intervals between recorded pictures may become large.
•If you repeatedly record or erase pictures, intervals between recorded pictures may become large. In this case, back up your important data on a PC, and format your card using this Camcorder.
Recording with the Built-in LED Video
Light
•The subject should be within 4.9 feet (1.5 metres) of the Camcorder.
•Using the LED Video Light reduces battery time.
•Set the LED Video Light to off when not in use.
•Do not look directly into the light.
•If the LED Video light is used with a Conversion lens attached, a slight vignetting (darkening around edges) effect occurs on the screen.
•Using the MagicPix Function at the same time will make conditions even brighter.
•The Video Light brightens images recorded in a
55