Panasonic NV RZ 15 B Charging Time and Maximum Time for Continuous Recording

∫Charging Time and Maximum Time for Continuous Recording

		NV-VZ14/VZ15	NV-RZ15	A
CGR-V14	A	1 h 40 min.	1 h 40 min.
(supplied)	B	2 h 55 min. (2 h 5 min.)	2 h 55 min.	B
CGR-V14S
CGR-V26S	A	3 h 10 min.	3 h 10 min.
	B 5 h 25 min. (4 h 5 min.)		5 h 25 min.
CGR-V53S	A	6 h 20 min.	6 h 20 min.
	B	10 h 50 min. (8 h.)	10 h 50 min.

Charging Time for a Full Charge Maximum Continuous Recording Time

Preparations

(The times shown in the above chart are approximations. The figures in parentheses show the recording time when using the LCD Monitor.)

The times listed above for your information indicate the duration of recording performed at an ambient temperature of 25°C and 60% relative humidity. The charging time may be longer when you charge the Battery at higher or lower temperature.

≥During recording or charging, the Battery becomes warm. However, this is normal.

≥To ensure precise indication of the remaining battery power, always use a fully charged Battery when attaching a Battery.

≥If you do not use the Battery for a long time, please read “Precautions for Storage” (p. 67).

≥Always set the [CAMERA/OFF/VCR] Switch to [OFF] before disconnecting the AC Mains Lead.

≥If you use the Movie Camera for a long time, it becomes warm. However, this is normal.

≥Do not use the AC Adaptor for any purposes other than supplying the unit with power or charging the Battery.

≥When not using the AC Adaptor, unplug its AC Mains Lead from the AC mains socket. To unplug, pull it by the plug, not by the lead.

≥This AC Adaptor works on any mains supply voltage between 110 and 240 V, and any frequency between 50 and 60 Hz. For use in other countries, an adaptor plug may be necessary.

≥Before connecting the AC Adaptor to the Movie Camera, be sure to set the [CAMERA/OFF/VCR] Switch to [OFF].

Remarks, etc.

≥Be sure to insert the mains plug completely into the correct socket.

≥If you have any problems with charging the Battery, refer to page 67.

≥Charge the Battery at a room temperature between 10°C and 30°C.

≥The AC Mains Lead’s outlet plug cannot be pushed fully into the AC Adaptor socket. A gap will remain as shown below.

Removing the Battery from the Movie Camera

Hold the Battery firmly to prevent it from dropping and pull it off while sliding the [2BATTERY EJECT] Lever

3

Connect the AC Adaptor to the [DC IN] Socket on the Movie Camera.

4

Connect the AC Mains Lead to the AC Adaptor and to an AC mains socket.

Plug into AC mains socket.

Plug into

AC Adaptor.

2in the direction of the arrow.

≥Be careful not to drop the Battery by accident.

≥Before removing the Battery, set the [CAMERA/OFF/ VCR] Switch to [OFF].

≥Never remove the Battery during recording or playback, because the tape would remain in contact with the video heads and this can cause damage to the heads and tape.

[2BATTERY EJECT] Lever

2

AC Mains Lead

7