AXIS Q604 Series
6.Turn the cable holders to keep the cables in place.
7.Put the camera base lid back in its original position and tighten the screws (torque 1.5 Nm).
8.Slide the unit holders on the network camera into the slots in the mounting bracket and rotate the camera unit.
9.Secure the network camera to the mounting bracket by tightening the screws.
10.Install the supplied midspan. See page 25.
Install the Midspan
The supplied midspan enables Axis network video products with high power consumption to receive data and power over the same network cable.
1.Connect the midspan (data in) to the network switch using a network cable.
2.Connect the midspan (data and power out) to the camera using the network cable that has been connected to the camera.
3.Connect the midspan to a grounded (earthed) mains power outlet
1Data and power out (connect to Axis product)
2Data in (connect to network)
3AC input LED indicator
4Port LED indicator
4.Make sure that the LEDs on the midspan indicate the correct conditions. See Midspan LED Indicators on page 13.
25