Bosch Appliances LTC 9385 instruction manual Final Assembly, Pull Seal Installation

LTC 9385 Series Instruction Manual Installation EN 14

5.13Final Assembly

5.13.1 Pull Seal Installation

If the breather hole is open, do NOT mount the housing in a position where the front face plate is pointed upward.

To maintain enclosure protection ratings of NEMA-4 and IP65, the pull seal (provided in the hardware kit) must be installed in the front face plate. It is recommended that the pull seal be installed in a cool, dry environment to prevent trapping moisture inside the housing. See FIGURE 14.

NOTE: Pull seal installation allows the housing’s front end to be pointed upward.

Front

Face

Plate

Breather Hole

FIGURE 14 Breather Hole

Proper installation of the pull seal is as follows:

1.If the housing assembly is not already removed from the base assembly, do so now; see the Disassembly and Mounting section at the beginning of these instructions.

2.Obtain a rubber pull seal from the hardware kit (Part Number 315 2569 001). An extra pull seal is also provided. See FIGURE 15.

FIGURE 15 Pull Seal

3.Insert the long end of the pull seal into the breather hole starting from the front side of the face plate. See FIGURE 16.

Housing

Face Plate

Pull Seal

FIGURE 16 Inserting the Pull Seal

4.Reach into the housing and grip the pull seal’s long end from the back of the front face plate. Steadily pull the long end until the head of the pull seal is flat against the front of the end cap. See FIGURE 17.

NOTE: The Pull Seal’s long end will stretch when pulled through the breather hole.

Housing (cut away)

Grip and Pull

FIGURE 17 Installing the Pull Seal

Bosch Security Systems January 26, 2005