Bosch Appliances LTC 9385 instruction manual Housing Assembly, Support Screw Adjustment

LTC 9385 Series Instruction Manual Installation EN 15

5.13.2 Housing Assembly

1.The lens support screw is provided to support the rail assembly. Adjustment will only be necessary if the rail assembly is rotated at angle other than horizontal. If the screw head is not touching the cover when the cover is installed, loosen the screw until it does. See FIGURE 18.

3.Align the cover holes with the base assembly holes and replace the two M4 screws and washers. This secures the cover onto the rest of the housing.

NOTE: Make sure the breather hole is located at the bottom of the housing. If it is not, remove both front retaining rings and the face plate. Orient them so the breather hole is located at the bottom and the gaps in the retaining rings are centered over the breather hole. See FIGURE 20.

Lens Support Screw

FIGURE 18 Support Screw Adjustment

2.Replace the cover onto the base assembly by grasping the cover and gently pushing it over the end cap and o-ring. Make sure the o-ring is not pinched. The safety cable can be routed between the cover and the base. See FIGURE 19.

Cover

Base Assembly

End Cap

FIGURE 19 Replacing the Cover

Front

Face

Plate

Retaining Ring

Breather Hole (centered)

FIGURE 20 Location of the Breather Hole

Bosch Security Systems January 26, 2005