Bosch Appliances GVS1000 Reset Button, Address Selection, Protocol Selection, Termination Jumpers

30 en Test SoftwareGlobal View Station 1000

6.2.1	Reset Button
	–	SW1 – resets the board to default settings
	–	Resetting should be used when changing the system address or communication protocol
		when the unit is powered

6.2.2	Address Selection
	– DIP1 – Switches 1-4
	– Switches in various combinations of on/off will allow address setting of 1-16
	– Default address: 1
	– Address MUST be the same for Auxiliary Control board (in PSU), Camera Control board
	(in camera assembly), and Code Translator (in PSU)
	– See the GVS1000 Installation Manual for further details

6.2.3	Protocol Selection
	– For Biphase models, ensure Pelco D mode is enabled.
	– DIP1 – Switch 5
	– Switch ON: Pelco D mode
	– Switch OFF: Pelco P mode
	– Default: Pelco D mode (switch off)
	– Switch UP position is ON

6.2.4	System Communication
	– T1 – Connects to system input
	– to receive system communication from controller
	– required for both simplex (2-wire configuration) and duplex (4-wire configuration)
	– T2 – connects to system output
	– to send system communication to controller – OPTIONAL
	– required only for duplex (4-wire configuration)
	– LED10 – indicates communication traffic to the system (LED always on when diagnostics
	function engaged)

6.2.5	Self Test Diagnostic Function
	– DIP1 – Switch 6
	– Switch ON and jumper JP8 ON: diagnostics function on
	– Switch OFF and jumper JP8 OFF: diagnostics function off
	– Default: diagnostics function off (switch off, jumper JP8 OFF)
	– Tests Aux1 through 8 sequentially, and then tests motor Pan LEFT/RIGHT and Tilt UP/
	DOWN respectively
	– 3 seconds for each test function
	– Stops only at end of cycle

6.2.6	Termination Jumpers
	–	JP6 / JP7 – controls the impedance communication lines
		–	JP6 – T1 telemetry jumper
		–	JP7 – T2 telemetry jumper – ALWAYS OPEN
	–	JP8 – diagnostics tool jumper

6.2.7	Photocell Control Adjustments
	– CN7 – connection to photocell
	– VR1 – sensitivity adjustment for photocell switching
	–	CCW rotation decreases lux switch point
	–	CW rotation increases lux switch point

F.01U.173.867 2.0 2010.11 Operations Manual Bosch Security Systems, Inc.