Bosch Appliances VG5 100 user manual Inside, Low Voltage flashing, On monitor display

Page 16

16 en Troubleshooting GuideAutoDome 100 Series Fixed Camera

Inside of	– Check the status of the Heater Module (ON-66-ENTER).
EnviroDome bubble	If status reports Heater No Power, then:
is foggy	– Turn off the power to the AutoDome.
	– Check the FX103 fuse in the Power Supply Box for power (24 V) to the heater module.
	If O.K., then:
	– Check all wiring and connector pins to the heater module.

Low Voltage flashing	– If using a non-Bosch power supply, confirm that it meets the Bosch AutoDome power
on monitor display	ratings. See the AutoDome Datasheet for specifications.
	If O.K., then:
	– Check the mains input line voltage.
	If O.K., then:
	– Check that the maximum wire length from the power supply has not been exceeded.
	See the VG5 AutoDome Installation Manual.
	If O.K., then:
	– Measure the AC voltage input to the camera while power is applied to the camera. The
	voltage must be ≥ 21 VAC to stop the message.

F.01U.216.346 1.0 2011.04

User Manual

Bosch Security Systems, Inc.

Image 16

Contents AutoDome 100 Series Fixed Camera Page Table of Contents Configuring the Camera Camera SetupDescription 2Positioning the Camera Camera Module Lock TabHorizontal pan Thumbscrew Tilt Wheel ThumbscrewAdjusting Focal Length Zoom and Focus Advanced Setup Accessing and Navigating MenusMain Menu Function Main MenuMain Menu ALC SubmenuALC Shutgain Submenu Function Selections DescriptionALC Shutgain DAY/NIGHT Submenu Enhanced Submenu Color SubmenuInstall Menu Functions Install MenuBack Light Compensation BLC Submenu Functions Selections DescriptionInstall Menu Camera ID SubmenuTroubleshooting Guide If O.K., then If using a non-Bosch power supplyIf O.K., then If there is power to the AutoDome, then VG5 AutoDome Operation and ControlAccess Camera AccessDoes not switch If O.K., then Automatically when No Remote MenuLow Voltage flashing InsideOn monitor display Page Page Page Bosch Security Systems, Inc