AutoDome 100 Series Fixed CameraPositioning the Camera en 5
2Positioning the Camera
The camera module position can be adjusted along the horizontal, vertical, and diagonal (for azimuth) axes. When adjusting the position, ensure that the picture displayed on the monitor is level. After the covert liner is removed, position the camera by performing the following steps:
WARNING!
To prevent damage to the camera module do not rotate the camera past its stops.
1.For horizontal (pan) adjustment, loosen the thumbscrew at the platform base and rotate the camera (left or right) to the desired position. The camera can be rotated up to 360º between stops. If it hits the stop before achieving the desired position, rotate it in the opposite direction. Retighten the thumbscrew to secure the camera.
2.For vertical adjustment (tilt), loosen the thumbscrew at the tilt wheel and position the camera (up or down) to the desired position. The camera can be tilted up to 110º between stops. Retighten the thumbscrew to secure the camera.
3.To compensate for angled ceilings or sidewall mounts, push the camera inward toward its base and rotate it until the image on the monitor is horizontal. The camera can be rotated up to 300º between stops.
CAUTION!
The CCD image sensors are highly sensitive and require special care for proper performance and extended lifetime. Do not expose it to direct sunlight or bright spotlights in operating and
Figure 2.1 Camera Position Adjustments
Ref | Description |
1 | Camera Module Lock Tab |
2 | Horizontal (pan) Thumbscrew |
3 | Tilt Wheel Thumbscrew |
4 | Diagonal Adj. |
Bosch Security Systems, Inc. | User Manual | F.01U.216.346 1.0 2011.04 |