Bosch Appliances 1200 Rotating the Hard Drive Cage, Removing and Installing Hard Drives

1200 Series IP Video Storage SystemChassis Setup and Maintenance en 11

5.2 Rotating the Hard Drive Cage

In order to access and install components in the chassis interior, it is necessary to rotate the hard drive cage. This will provide sufficient room to install and configure the chassis components.

Rotating the Hard Drive Cage

1.Disconnect the chassis from any power source.

2.Lift the release tab (A).

3.Rotate the hard disk drive cage (B) outward.

5.3 Removing and Installing Hard Drives

The 1200 Series chassis must be powered-down before hard drives can be removed from the hard drive carriers.

Removing and Installing Hard Drives

1.Disconnect the chassis from any power source.

2.Rotate the hard drive cage outward 90 degrees as described in section Rotating the Hard Drive Cage.

3.Disconnect all of the cables from the hard drive.

4.Press the release tab on the side of the hard drive carrier that is to be removed from the hard drive cage.

Bosch Sicherheitssysteme GmbH Installation Manual DOC V1 2010.08