Bosch Appliances 1200 installation manual Safety Instructions, Overview, Preparing for Setup

4 en Safety Instructions1200 Series IP Video Storage System

1	Safety Instructions
1.1	Overview
	This chapter provides a quick setup checklist to get your chassis up and running. Following
	the steps in the order given should enable you to have your chassis setup and operational
	within a minimal amount of time. This quick setup assumes that you are an experienced
	technician, famailiar with common concepts and terminology.
1.2	Warnings and Precautions
	You should inspect the box the chassis was shipped in and note if it was damaged in any way.
	If the chassis itself shows damage, file a damage claim with carrier who delivered your
	system.
	Avoid areas where heat, electrical noise and eletromagnetic fields are generated. Position the
	chassis near at least one grounded power outlet.
1.3	Preparing for Setup
	The 1200 Series chassis contains many features that are unique to the 1200 Series chassis
	model. Read this manual in its entirety before beginning the installation procedure.
1.4	Electrical Safety Precautions
	Basic electrical safety precautions should be followed to protect yourself from harm and the
	1200 Series from damage:
	– Be aware of the locations of the power on/off switch on the chassis as well as the room’s

emergency power-off switch, disconnection switch or electrical outlet. If an electrical accident occurs, you can then quickly remove power from the system.

– Do not work alone when working with high voltage components.

– Power should always be disconnected from the system when removing or installing main system components, such as the serverboard, memory modules and optical device drives. When disconnecting the power, you should first power down the system with the operating system and then unplug the power cords from all the power supply modules in the system.

– When working around exposed electrical circuits, another person who is familiar with the power-off controls should be nearby to switch off the power, if necessary.

– Use only one hand when working with powered-on electrical equipment. This is to avoid making a complete circuit, which will cause electrical shock. Use extreme caution when using metal tools, which can easily damage any electrical components or circuit boards they come into contact with.

– Do not use mats designed to decrease electrostatic discharge as protection from electrical shock. Instead, use rubber mats that have been specifically designed as electrical insulators.

– The power supply power cord must include a grounding plug and must be plugged into a grounded electrical outlet.

– Serverboard battery: CAUTION - There is a danger of explosion if the onboard battery is installed upside down, which will reverse its polarities This battery must be replaced only with the same or an equivalent type recommended by the manufacturer. Dispose of used batteries according to the manufacturer’s instructions.

DOC V1 2010.08 Installation Manual Bosch Sicherheitssysteme GmbH