Axis Communications 290A installation instructions Installing the housing

Page 3

290A Installation Instructions

3

Installing the housing

Recommendation: Keep the housing closed when possible during the installation to prevent the build-up of dust and moisture inside the housing.

Important: This product should be installed by certified electrical technicians in compliance with local laws and regulations.

Warning: High voltage - the apparatus works on 100-240VAC. Always ensure that the power is disconnected before starting any work or opening the housing..

8

 

 

 

 

9

 

 

No.

 

10

 

 

 

 

 

8.

Housing

12

 

 

9. White rubber seal

 

11

10.

Widget

 

 

 

 

11.

Swivel

 

 

 

13

12.

Bracket arm

 

 

 

13.

Positioning bolt

 

 

 

 

1.Detach the bracket from the housing by unscrewing the positioning bolt (13). Use the large allen key (1) to do this. Continue until the swivel (11) (still attached to the housing) comes completely loose from the bracket arm (12). The positioning bolt (13) is held in the bracket arm (12) by a plastic washer inside.

2.Detach the swivel (11) from the housing by loosening its four screws. Use the small allen key (2) to do this. The four screws are held in the swivel (11) by plastic washers.

3.Position the bracket arm (12) on the wall in the position required and drill four fixing indicators. Remove the bracket arm and drill the four holes (using an 11 mm drill bit) to the depth and size (50 mm) of the plugs provided.

4.Route the cables through the rear of the bracket arm and pull them out at the front. Pull out at least 60 cm of cable to complete the installation.

Warning: Be careful when routing the cables through the bracket arm. A damaged cable may damage the camera, the housing and/or other system equipment.

5.Position the swivel (11) on the end of the bracket arm (12) with the two cables coming through the open slot. Ensure that the swivel is positioned with F (front) at the front and R (rear) at the back.

Image 3
Contents Unpacking Fitting the camera inside the housingRouting the cables Installing the housing Power Network Cablecable Connecting the camera Axis 211A Completing the installation Specifications Maintenance