Samsung SNC-B2331(P) user manual Auto Network Setup

6.Click [OK].

Manual network setup will be completed.

7.When the manual setup including <IP> is completed, the camera will restart.

If the IP router has more than one camera connected

Configure the IP related settings and the Port related settings distinctly with each other.

Category		Camera #1	Camera #2
	IP Address	192.168.1.200	192.168.1.201
IP related settings	Subnet Mask	255.255.255.0	255.255.255.0
	Gateway	192.168.1.1	192.168.1.1
	HTTP Port	80	10000
	Device Port	60001	10001
Port related settings	TCP Port	60002	10002
	UDP Port	60003	10003
	Upload Port	60004	10004
	Multicast Port	60005	10005

M If the <HTTP Port> is set other than 80, you must provide the <PORT> number in the address bar of the Internet browser before you can access the camera.

ex) http://IP address : HTTP Port http://192.168.1.201:10000

Auto Network Setup

Run <IP Installer.exe> to display the camera search list.

At the initial startup, both [Auto Set] and [Manual Set] will be grayed out.

M For cameras found with the IPv6 setting, these buttons will be grayed out as the cameras do not support this function.

1.Select a camera in the search list.

Find the MAC (Ethernet) address labeled on the rear of the camera.

Both the [Auto Set] and [Manual Set] buttons will be activated.

2.Click [Auto Set].

The AUTO SET dialog appears.

The <IP Address>, <Subnet Mask>, and <Gateway> will be set automatically.

● NETWORK CONNECTION AND SETUP

English _33