D-Link DCS-5635, DCS-5605 manual Camera Installation

Page 9

Camera Installation

It is recommended to connect the camera to your computer and configure it before mounting.

Step 1 - Connect an Ethernet cable to the network cable connector located on the DCS-5605/DCS-5635’s back panel and attach it to the network.

Step 2 - Attach the supplied power supply to the power input connector located on the DCS-5605/DCS-5635’s back panel and connect the other end to your wall outlet.

D-Link DCS-5605/DCS-5635 User Manual

8

Image 9

Contents Page Table of Contents Page Package Contents Introduction HIGH-PERFORMANCE Surveillance SolutionPage Rear Hardware OverviewFront Camera Installation Installation Wizard Page Page Page Page Page Page Click Install to continue Click Finish Page Page Click Next to continue Page Mounting Page Page Using the Camera with a Router Configuration Live Video Overview Page Setup Connection SetupDetection Setup Internet Connection Setup Wizard Page Page Click Apply to finish Network Setup Forwarding LAN SettingsPort Settings Https settings Wireless Setup DCS-5635 only Channel Auto Authentication WPK2-PSK Encryption Tkip Setting up a Wireless Connection with WPS Dynamic Ddns Image Setup Auto Gain Preferred ModeControl Back LightVideo Profiles Audio and VideoPage Sensitivity Motion DetectionDrawing Mode Click the Motion Detection Setup Wizard button Motion Detection Setup WizardClick the Enable Video Motion box Page Page Time and Date Preset Position Positions Patrol PositionRecording Samba Network Drive Select to use Samba Snapshot Snapshot Mail SettingFTP Setting SD Card ICR AdvancedConnector Connector Definition for the CameraDigital Output External I/O PortExternal Trigger Configuration Under Recording Method, select Event Based and then select Page Page Admin MaintenanceDevice/PT Setting System Firmware Upgrade Device Info StatusLog Help Appendix Frequently Asked QuestionsPage Noisy images occur. How can I solve the problem? How to Ping Your IP Address Using & Configuring 3G Compatible Cell Phones Select Open Select RealPlayer Play from RealPlayerSelect Open Press Options Select DownloadSelect Navigation Options Select Go to web address Page Play from PVPlayer Select Open Reset Button Reset and RestoreEnabling UPnP for Windows XP Check the Universal Plug and Play box and then click OK Click Add/Remove Windows ComponentsClick Finish Page Package Contents Technical SpecificationsSystem Requirements Dimensions L x W x HInternet Support Contacting Technical SupportWarranty Page Page Registration