C H A P T E R 2
Camera Installation
This chapter provides information and instructions for installing the Cisco Video Surveillance 6020 IP Camera, and includes the following topics:
•Installation Guidelines, page
•Warnings Before Installation, page
•IP Camera Installation, page
Installation Guidelines
This section describes how to install the IP camera. Before installing, review these guidelines:
•The IP camera requires a network cable and a connection to a standard 10/100BaseT router or switch. To power the IP camera with Power over Ethernet (PoE), a switch must be 802.3af compliant.
•If you are using the IP camera on a network connection that does not provide PoE, you must use a Cisco 12 VDC power adapter (Cisco part number
•If you are using an external speaker, microphone, input device, output device, or pan/tilt control device, you must configure additional settings after installing and performing the initial set up of the IP camera before the external device can fully operate. For detailed information about these settings, see the Cisco Video Surveillance 6000 Series IP Camera Configuration Guide.
•If you do not connect an external device (speaker, microphone, input, output, or pan/tilt control) when you perform the following installation procedure, you can install any of these devices later.
Warnings Before Installation
• Power off the IP Camera as soon as smoke | • Keep the IP Camera away from water. If |
or unusual odors are detected. | the IP Camera becomes wet, power off |
Contact your distributor in the event of this | immediately. |
| |
happening. | Contact your distributor in the event of this |
| happening. |
Cisco Video Surveillance 6020 IP Camera Installation Guide
|
| ||
|
|