Cisco Systems 6020 IP manual IP Camera Installation, Mounting the IP Camera Directly to a Surface

Page 16

Chapter 2 Camera Installation

IP Camera Installation

IP Camera Installation

Install the 6020 IP camera using one of the following procedures:

Mounting the IP Camera Directly to a Surface, page 2-4

Mounting the IP Camera Flush with a Surface, page 2-7

Mounting the IP camera with a Vandal Resistant Enclosure, page 2-10

Mounting the IP Camera Directly to a Surface

To directly mount the 6020 IP camera to a surface, complete the following steps:

Procedure

Step 1 Attach the included alignment sticker to the ceiling or wall.

Step 2 Using the circle marks on the sticker, drill 2 pilot holes symmetrically on each side into the ceiling or wall. Then hammer the included wall anchors into the holes.

Step 3 Secure the IP camera to the ceiling or wall with the included screws.

Step 4 Connect an STP (shielded twisted pair) Category 5 or higher network cable to the LAN port on the back of the camera. Connect the other end of the network cable to a 10/100/BaseT router or switch.

If your network provides PoE, the IP camera powers on.

Step 5 (Optional) Connect the following cables to the GPIO terminal block:

External power cable if Power over Ethernet (PoE) is not available.

I/O cables for external input or out put devices, such as sensors or alarms.

Cisco Video Surveillance 6020 IP Camera Installation Guide

2-4

OL-28120-02

 

 

Image 16
Contents Cisco Video Surveillance 6020 IP Camera Installation Guide Americas HeadquartersCisco Video Surveillance 6020 IP Camera Installation Guide N T E N T S Contents Overview OrganizationOL-28120-02 Overview IntroductionPackage Contents IP Camera Physical Details IP Camera DetailsMicrophone Video OutputGeneral Purpose I/O Terminal Block Pin DescriptionOL-28120-02 Camera Installation Installation GuidelinesCamera Installation Camera Installation Procedure IP Camera InstallationMounting the IP Camera Directly to a Surface 3 4 5 6 7 What to do next Mounting the IP Camera Flush with a Surface Pin Description Camera Installation IP Camera Installation Mounting the IP camera with a Vandal Resistant Enclosure Pin Description Camera Installation IP Camera Installation What to do next OL-28120-02 Performing the Initial Setup of the IP Camera Before you BeginProtocol//ipaddress Understanding the IP Camera User Interface IP Camera Window LinksLink Description RefreshIP Camera Windows Field DescriptionIO Port Status Adjusting the IP Camera Focus and ZoomStream 1 and Stream Powering the IP Camera On or Off Resetting the IP CameraReset Type Procedure Remarks Viewing Live VideoControl Description Video controlsImage tools Hotspot Zoom button Hotspot Pan/TiltRestore button Audio Control Disable SpeakerEnable Speaker Mirror buttonCamera Settings Picture AdjustmentsExposure Control Advanced Settings Motion detectionMotion detection controls Enable Motion Detection check box Save Settings button Reset buttonFull Screen check Focus/ZoomPrivacy Zone Managing the Local StoragePrivacy Zone controls Downloading and Installing the Cisco SD Utility Formatting the SD Memory CardClick Download Software Click Format MMCDownloading Encrypted Video Files from the SD Memory Card Deleting Encrypted Video Files from the SD Memory CardDecrypting Encrypted Video Files OL-28120-02 D E IN-2 IN-3 IN-4