1. General
This booklet briefly outlines where and how to install the air conditioning system. Please read over the entire set of instructions for the indoor and outdoor units and make sure all accessory parts listed are with the system before beginning.
1-1. Tools Required for Installation (not supplied)
1.Standard screwdriver
2.Phillips head screwdriver
3.Knife or wire stripper
4.Tape measure
5.Carpenter’s level
1-2. Accessories Supplied with Unit Table 1
6.Sabre saw or key hole saw
7.Hacksaw
8.Core bits
9.Hammer
10.Drill
11.Tube cutter
12.Tube flaring tool
13.Torque wrench
14.Adjustable wrench
15.Reamer (for deburring)
Parts | Figure | Q’ty | Parts | Figure | Q’ty | Parts | Figure | Q’ty |
Remote |
| 1 | Air clean filter |
| 2 | Rawl plug |
| 8 |
control unit |
|
|
| |||||
Remote control |
| 1 | Tapping screw | 10 | Drain hose |
| 1 | |
| Phillips |
| ||||||
unit holder |
| adapter |
| |||||
|
|
| 5/32 ⋅ 5/8" (4⋅16 mm) |
|
|
| ||
|
|
|
|
|
|
|
| |
AAA alkaline |
|
| Tapping screw | 2 | Flare insulation |
| 1 | |
| 2 | Phillips |
| |||||
battery |
|
| ||||||
|
|
| 5/32 ⋅ 13/32" (4⋅10 mm) |
|
|
|
| |
|
|
|
|
|
|
|
|
1-3. Optional Copper Tubing Kit
Copper tubing for connecting the outdoor unit to the indoor unit is available in kits which contain the narrow and wide tubing, fittings and insulation. Consult your nearest sales outlet or air conditioning workshop.
1-4. Type of Copper Tube and Insulation Material
2.Foamed polyethylene insulation for the specified copper tubes as required to precise length of tubing. Wall thickness of the insulation should be not less than 5/16" (8 mm).
3.Use insulated copper wire for field wiring. Wire size varies with the total length of wiring. Refer to
If you wish to purchase these materials separately from a local source, you will need:
CAUTION
1. Deoxidized annealed copper tube for refrigerant tub- ing as detailed in Table 2.
Cut each tube to the appropriate lengths 1' to 1'4" (30 cm to 40 cm) to dampen vibration between units.
Table 2
Model | Narrow Tube | Wide Tube | |||
|
|
|
| ||
Outer Dia. | Thickness | Outer Dia. | Thickness | ||
| |||||
|
|
|
|
| |
KHS3082 | 3/8" (9.52 mm) | 0.0314" (0.8 mm) | 5/8" (15.88 mm) | 0.0393" (1.0 mm) | |
|
|
|
|
| |
KHS3682 | 3/8" (9.52 mm) | 0.0314" (0.8 mm) | 5/8" (15.88 mm) | 0.0393" (1.0 mm) | |
|
|
|
|
| |
Check local electrical codes and regulations before obtaining wire. Also, check any specified instructions or limitations.
3
