ADJUSTING THE AIRFLOW DIRECTION 
1. Horizontal
The horizontal airflow can be adjusted by moving the vertical vanes with your hands to the left or right.
CAUTION
When the humidity is high, the vertical vanes should be in the front position during the cooling or dehumidifying operation. If the vertical vanes are positioned all of the way to the right or left, condensation may begin to form around the air vent and drip down.
2. Vertical
The vertical airflow can be adjusted by moving the flap with the remote control unit. Do not move the flap with your hands. Confirm that the remote control unit has been turned on. Use the FLAP button to set either the sweep function or one of the six airflow direction settings.
A. Sweep function
The flap starts moving up and down to deliver air over the sweep range.
B. Setting the airflow manually |
| SWEEP |
Referring to the above COOL |
| |
illustration, use the | DRY | SWEEP |
FLAP button to set the |
|
|
airflow direction within |
| HEAT |
the range used during |
| |
| FAN | |
the heating, cooling, or |
| |
|
| |
dehumidifying |
|
|
operation. |
|
|
C. Auto flap function
The flap is set to the recommended position.
NOTE
•The flap automatically closes when the unit is off.
•During the heating operation, the fan speed will be very low and the flap will be in the horizontal position (position 
) until the air being blown out of the unit begins to warm. Once the air warms up, the flap position and fan speed change to the settings specified with the remote control unit.
CAUTION
•Use the FLAP button on the remote control unit to adjust the position of the flap. If you move the flap by hand, the flap position according to the remote control unit and the actual flap position may no longer match. If this should happen, shut off the unit, wait for the flap to close, and then turn on the unit again; the flap position will now be normal again.
•Do not have the flap pointed down during cooling operation. Condensation may begin to form around the air vent and drip down.
OPERATION WITHOUT THE REMOTE CONTROL UNIT 
INDOOR UNIT
OPERATION lamp
OPERATION button (ON/OFF)
If you have lost the remote control unit or it has trouble, follow the steps below.
When the air conditioner is not running
Each time the OPERATION button is pressed, the type of operation conducted is indicated by the changing color of the OPERATION lamp. Press the button and select the lamp color that suits your preference for operation.
Cooling operation |
| Heating |
| Stop |
|
| |||
(green) |
| operation (red) | (lamp off) | |
NOTE
The temperature is set to the room temperature minus 4°F during the cooling operation and to the room temperature plus 4°F during the heating operation, and the fan speed and flap are set to Auto.
CARE AND CLEANING 
1.For safety, be sure to turn the air
conditioner off and also to disconnect the power before cleaning.
2.Do not pour water on the indoor unit to clean it. This will damage the internal components and cause an electric shock hazard.
Casing and Grille (Indoor Unit)
Clean the casing and grille of the indoor unit with a vacuum cleaner brush, or wipe them with a clean, soft cloth.
15 | |
|
