2-2. Outdoor Unit
AVOID:
●heat sources, exhaust fans, etc. (Fig. 4)
●damp, humid or uneven locations.
DO:
●choose a place as cool as possible.
●choose a place that is well ventilated.
●install in a location where at least two sides are unob- structed, so that the flow of air at the intake port or exhaust port is not blocked, and so that sufficient space is ensured for maintenance to be carried out without trouble. In general the top also must be unob- structed. (Fig. 5a)
●provide a solid base (level concrete pad, concrete block, 6" x 1'4" (15 x 40 cm) beams or equal), a minimum of 6" (15 cm) above ground level to reduce humidity and pro- tect the unit against possible water damage and decreased service life. (Figs. 5b and 5c)
NO |
| Exhaust fan |
|
Hot air
Heat source
Outdoor unit
Fig. 4
Obstacle above
*3 |
|
|
|
|
|
Air intake A |
|
| discharge | B | C |
*2 | Min. 10" | *4 |
|
| |
(25 cm) | Air |
| Obstacle | ||
Min. | Min. |
|
| ||
6" (15 cm) Air discharge |
|
|
CAUTION
A solid base must not cover the hole of the bottom plate.
3'3" (100 cm) |
|
*1 |
|
Ground | Min. 8" (20 cm) |
●install cushion rubber under unit’s feet to reduce vibration and noise. (Fig. 5d)
●use lug bolts or equal to bolt down unit, reducing vibration and noise.
●install in a location where no antenna of a television or radio exists within 10' (3 m).
Fig. 5a | Air intake |
|
CAUTION
Drain holes
Fig. 5b
●Concerning
●If wall *1 is on the
Air intake
Concrete or equal
About |
|
|
1'4" | (40 | cm) |
| ||
|
|
Anchor bolts (4 pcs.)
Min. 6" (15 cm)
6" | (15 | cm) |
| ||
|
|
About
Cushion rubber
(Locally purchased)
Fig. 5c | Fig. 5d |
5
