Cisco Systems OL-28645-01 manual Mounting the IP Camera Flush with a Surface, Procedure

Chapter 2 Camera Installation

IP Camera Installation

Mounting the IP Camera Flush with a Surface

To mount the 3520 IP camera flush with a surface, complete the following steps:

Procedure

Step 1 Secure the IP camera inside the camera housing using the two included screws.

Step 2 Remove the ceiling tile from the location at which you want to mount the IP dome and cut a 7-3/4 inch (19.68 cm) diameter hole in the center of the tile.

Step 3 Place the camera housing through the hole that you cut in the ceiling tile.

Step 4 (Optional) Place a ceiling tile mount over the camera housing.

Orient the ceiling tile mount so that it is flush with the back surface of the ceiling tile.

Step 5 Use a Phillips-head screwdriver to turn the anchor screws clockwise and spin the anchor clips outward into the locking position and to secure the anchor clips.

Cisco Video Surveillance 3520 IP Camera Installation Guide

OL-28645-01 2-7