Cisco Systems OL-28645-01 manual Pin Description

Page 20

Chapter 2 Camera Installation

IP Camera Installation

The anchor clips twist over the ceiling tile. Turn the anchor clip screws until the camera housing is snug against the ceiling tile. Do not over tighten the screws.

Step 6 Connect a shielded twisted pair (STP) Category 5 or higher network cable to the LAN port on the back of the camera through the cutout in the camera housing. Connect the other end of the network cable to a 10/100/BaseT router or switch.

If your network provides PoE, the IP camera powers on.

Step 7 (Optional) Connect the following cables to the GPIO terminal block on the IP camera through the cutout in the camera housing:

External power cable to the GPIO terminal block if PoE is not available.

(Optional) I/O cables for external input or out put devices, such as sensors or alarms, to the GPIO terminal block

The GPIO terminal block pin locations and descriptions are as follows:

1 2 3 4 5 6 7 8

Pin

Description

 

 

1

12 VDC-

 

 

2

12 VDC+

 

 

3

24 VAC

 

 

4

24 VAC

 

 

5

DI-

 

 

6

DI+

 

 

7

DO-

 

 

8

DO+

 

 

Step 8 Replace the ceiling tile with the camera installed.

Step 9 (Optional) Use a mini cable with BNC connector to temporarily attach an NTSC or PAL compliant analog video display device to the analog video out port on the IP camera.

You may need to temporarily remove and adjacent ceiling tile to access the analog video out port.

Cisco Video Surveillance 3520 IP Camera Installation Guide

2-8

OL-28645-01

 

 

Image 20
Contents Cisco Video Surveillance 3520 IP Camera Installation Guide Americas HeadquartersCisco Video Surveillance 3520 IP Camera Installation Guide N T E N T S OL-28645-01 Overview OrganizationOL-28645-01 Overview IntroductionPackage Contents IP Camera Physical Details IP Camera DetailsExternal microphone Video outputGeneral Purpose I/O Terminal Block Pin DescriptionOL-28645-01 Camera Installation Installation GuidelinesCamera Installation Camera Installation Mounting the IP Camera Directly to a Surface IP Camera InstallationProcedure 3 4 5 6 7 What to do next Mounting the IP Camera Flush with a Surface Pin Description Camera Installation IP Camera Installation Zoom Focus Mounting the IP camera with a Vandal Resistant Enclosure Pin Description Camera Installation IP Camera Installation What to do next Performing the Initial Setup of the IP Camera Before you BeginProtocol//ipaddress Understanding the IP Camera User Interface IP Camera Window LinksLink Description RefreshIP Camera Windows Field DescriptionPowering the IP Camera On or Off Resetting the IP CameraIO Port Status Stream 1 and StreamReset Type Procedure Remarks Viewing Live VideoControl Description Video controlsImage tools Hotspot Zoom button Restore buttonVideo image controls Hotspot Pan/Tilt Save Snapshot buttonMirror button Full Screen buttonFull Screen check Motion detection controls Enable MotionDetection check box Save Settings button D E See also video Saturation Sensitivity, for motion detection