function & installation
| VIDEO | |
| 6 | |
1 | 2 | |
POWER | ||
|
45
3
[THE OTHER SIDE VIEW]
FUNCTION
1Protective Film over Front Glass : Remove this film before operating the Camera.
2Focus/Zoom Lever Bolt Screws: Used to fix the Focus/Zoom ring to the lens internally. Be careful not to lose this small bolt screws which need not be touched other than by a service technician.
3Focus/Zoom Ring Fixing Screws: Used to fix the Focus/Zoom Ring at the desired position after adjusting the lens angle and focus setting as described below.
4Focus and Zoom Ring: These two rings are used to accurately adjust the viewing angle and to sharply focus all objects within the lens field of view.
-Loosen the fixing screws ( 3 ) to turn the Zoom and Focus ring.
i)To widen the viewing angle turn the “Zoom Ring” to “W” (Wide).
ii)To obtain a closer view turn this ring to “T” (Tele).
-After adjustment of the viewing angle then adjust the “Focus Ring” between “N” (Near) or “” (Far) until the sharpest focus is achieved.
- Then tighten the fixing screws ( 3 ) on each ring.
-After tightening you should check that angle and focus is still accurate.
5 DC Level Volume Screw Cap :
-Loosen the DC level volume screw cap on the camera body.
i)For a brighter screen turn the DC level volume slowly toward “H”
ii)For a darker screen turn it toward “L” (clockwise) with a driver.
6Bracket : Used to install the camera to the desired location.
ENG
function & installation _03