AVerMedia User’s Manual
EYES Pro/MP2016/MP3000/MP5000
3.Test
You can test the sensor immediately after you install it. Click
, and if the test area turns red, it indicates the sensor is Closed/ON. If it turns green, it indicates the sensor is Open/Off.
4.Enable
Check Enable box to activate the previous setting.
5.Update
Click this button to update the setting.
6.Restore
Click Restore to abort all the changes you made so far and restore your last settings.
Relays
Relays to list the relays already been configured. 
Relays to add a new relay. Click any desired relay to enter the setup screen of that relay.
AVerMedia User’s Manual
EYES Pro/MP2016/MP3000/MP5000
1.Relay ID
In the No. field, you can see the relay number. In the Name field, you can set the name for the relay.
2.Content
Since each card can connect to one External I/O Box, and each box supports 3 relay outputs, you can easily determine the Card No. and Output No. as to where this relay is connected.
In the Comment field you can add any remarks you have for this relay. Any comment you left can serve as a reminder for the system manager.
3.Test
You can test the relay immediately after you install it. Click
, and if the test area turns red, it indicates the relay is ON/HIGH and generates an output signal. If it turns green, it indicates the relay is OFF/LOW.
4.Enable
Check Enable box to activate the previous setting.
5.Update
Click this button to update the setting.
6.Restore
Click 
to abort all the changes you made so far and restore your last settings.
After the sensors and relays are configured, you can go to 
Alarm to create alarms that will alert you when specified events take place.
51 | 52 |