Apple G4 manual

Troubleshooting General/ Power Supply Verification - 25

3.Power Mac G4 (Gigabit Ethernet/Digital Audio) (see Figure

2 ) :

Connect the black lead of the volt meter to pin 11 of the 22- pin power supply connector. Connect the red lead of the volt meter to pin 22 of the power supply connector. The volt meter should measure approximately +28V.

If you do not get a reading of +28V, re-check the volt meter connections and measure the voltage again. If voltage is still not present, replace the power supply; otherwise, go to the next step.

If you do measure +28V on pin 22, the power supply is likely OK. Go to the next step for further verification.