Troubleshooting | General/ Power Supply Verification - 30 |
|
|
not present, replace the power supply; otherwise, go to the next step.
8.Connect the black lead of the volt meter to pin 16 of the power supply connector for AGP and PCI models or pin 11 for Gigabit Ethernet/DIgital Audio/QuickSilver/QuickSilver 2002 mod- els. Connect the red lead of the volt meter to pin 4 of the power supply connector. The volt meter should measure approxi- mately +5V.
If you do not get a reading of +5V,
9.Measure the voltage of pin 10 on the power supply connector. The voltage should measure approximately +12V.
If you do not get a reading of +12V,