Paradyne 8820, 8620 manual AtmInterfaceMaxActiveVciBits Object atmInterfaceConfEntry

6.1.1.6“atmInterfaceMaxActiveVciBits” Object (atmInterfaceConfEntry 6)

This object contains the maximum number of active VCI bits configured for use at this ATM interface.

Table 1-45.	atmInterfaceMaxActiveVciBits
Interface		atmInterfaceMaxActiveVciBits
DSLATM		6
ATMUP		10
AAL5		6

6.1.1.7“atmInterfaceIlmiVpi” Object (atmInterfaceConfEntry 7)

6.1.1.8This object contains the VPI value of the VCC supporting the ILMI on the ATM Interface. “atmInterfaceIlmiVci” Object (atmInterfaceConfEntry 8)

Table 1-46.	atmInterfaceIlmiVpi
Interface		atmInterfaceIlmiVpi	Access
DSLATM		0	Read-Only
ATMUP		0	Read-Only
AAL5		0	Read-Only

This object contains the VCI value of the VCC supporting the ILMI on the ATM Interface. .

Table 1-47.	atmInterfaceIlmiVci
Interface		atmInterfaceIlmiVci	Access
DSLATM		0	Read-Only
ATMUP		16	Read-Only
AAL5		0	Read-Only

6.1.1.9“atmInterfaceMyNeighborIpAddress” Object (atmInterfaceConfEntry 11)

In Hybrid Management Model, the value of this object contains the IP address of the neighbor system connected to the far end of this interface, to which a Network Management Station can send SNMP messages, as IP datagrams sent to UDP port 161, in order to access network management information concerning the operation of that system.

Implementation Note: for those ATM interfaces over xDSL interfaces, the value of this object is obtained from NMS station when the endpoint IP address is assigned for the purpose of the persistent management of the endpoint.

44 November 2003 8000-A2-GB30-10