Philips 231T1L user manual Start to use, Switch your TV on/off or to standby Switch channels

Page 14

5. Start to use

This section helps you perform basicTV operations.

Note

‡If you cannot locate your remote control and want to switch on the TV from standby, press CH +/- at the side of the TV.

Switch your TV on/off or to standby

Switch channels

To switch on

‡ If the standby indicator is off, press POWER at the side of the TV.

‡ If the standby indicator is red, press (Standby-On) on the remote control.

To switch to standby

‡ Press (Standby-On) on the remote control.

ÈThe standby indicator switches to red.

To switch off

‡ Press POWER at the side of the TV.

ÈThe standby indicator switches off.

Tip

‡Though your TV consumes very little power when in standby, energy continues to be consumed. When not in use for an extended period of time, disconnect the TV power cable from the power outlet.

‡ Press CH ^/v on the remote control or CH +/- on the side of the TV.

‡ Enter a channel number using the Numeric buttons.

‡ Use the channel grid.

Note

‡When you use a favourite list, you can only select those channels in the list.

12EN

Image 14
Contents 231T1L Register your product and get support atSerial Contents Koninklijke Philips Electronics N.V.All rights reserved Copyright ‡ 5LVNRIVKRUWFLUFXLWRUÀUH ‡ Never place the TV, remote control‡ 5LVNRIHOHFWULFVKRFNRUÀUH Screen care PC in VGA and Audio Audio and video input from a computer Back connectorGet started and connect your devices Audio and video output to analogue Device EXT 1 ScartOUT L/R Spdif OUTSide connector Front and side controls Remote controlControls MIX SoundMENU/EXIT ~ TeletextFAV Index€ Subtitle ‚ CH-LISTThis section helps you perform basicTV operations Switch your TV on/off or to standby Switch channelsStart to use Adjust TV volume Watch connected devicesTuner/Reception Transmission PowerProduct information Supported TV mountsAudio CarrierAnalog TV only Using TV signal as the input sourceTo adjust the country for auto tuning Audio and 2nd Audio 1st Audio and 2nd Audio Digital TV onlyChannel Scan Channel Scan scan both the digitalChannel Press OK button to scan Update ScanSingle RF Scan Digital TV only 3UHVV2.ɽEXWWRQWR6FDQ8SRU Down Analog Manual Scan Analog TV onlyChannel Skip 3UHVV2.ɼɾEXWWRQWRVHOHFW Channels Channel SkipChannel Sort Swap Appendix Decoder Analog TV onlyAnalog Ch Fine Tune Analog TV only Feature setting highlights Using the TeletextChannel Block Using the EPGParental Menu setting Press OK button to set. a checked Channel is a block one Parental GuidanceInput Block Age RatingOAD update Set PasswordClean All Pixel policyTolerances listed in the following tables Proximity of Pixel DefectsPixel Defect Tolerances Model TV channel issues TroubleshootingGeneral TV issues Picture issuesComputer connection issues Sound issuesHdmi connection issues OthersEnglish