Philips CE153DR user manual Mount into the dashboard, Connect the DAB radio receiver, 5mm

Tip

•The pin arrangement for the ISO connectors depends on the type of your vehicle.To avoid damage to the unit, connect properly.

Connect the DAB radio receiver

Note

•The DAB radio receiver and DAB radio antenna are not bundled. Consult your local retailer for purchase.

•Make sure that no lead other than the DAB radio antenna contacts the antenna connector of the DAB radio receiver.

•Risk of injury: Never install the DAB radio receiver and its accessories on the airbag cover.

•Risk of overheating: Do not fix the DAB radio receiver to the metal surface of the main unit.

•Risk of electromagnetic interference: Do not install the DAB radio receiver over any sensors or vents.

•Risk of short circuit, malfunction, or damage to this product: Do not alter the cable of DAB radio receiver or dismantle the receiver box.

•Risk of damage to the DAB radio receiver: Never pull its cable when you remove it.

1 Connect the DAB radio receiver to the main unit.

2 Connect a DAB radio antenna to the DAB radio receiver.

8EN

3 Secure the DAB radio receiver to your car.

Mount into the dashboard

• If the car does not have an on-board drive or navigation computer, disconnect the negative terminal of the car battery.

• If the car battery is not disconnected, to avoid short-circuit, make sure that the bare wires do not touch each other.

1 Make sure that the car dashboard opening is within these measurements:

5mm

53mm