D-Link DCS-910/90 manual Router Set-Up and Installation, Access the Router with Your Web Browser

Page 52

Section 4 - Security

Router Set-Up and Installation

The following steps generally apply to any router that you have on your network. The D-Link DI-624 is used as an example to clarify the configuration process. Configure the initial settings of the DI-624 by following the steps outlined in the DI-624 Quick Installation Guide.

3 Access the Router with Your Web Browser

If you have cable or DSL Internet service, you will most likely have a dynamically assigned WAN IP Address. ‘Dynamic’ means that your router’s WAN IP address can change from time to time depending on your ISP. A dynamic WAN IP Address identifies your router on the public network and allows it to access the Internet. To find out what your router’s WAN IP Address is, go to the Status menu on your router and locate the WAN information for your router (as shown on the next page). The WAN IP Address will be listed. This will be the address that you will need to type in your Web browser to view your camera over the Internet.

Your WAN IP Address will be listed on the router’s

Status > Device Info page.

D-Link DCS-910/920 User Manual

52

Image 52
Contents Page Table of Contents Warranty Registration Package Contents System RequirementsIntroduction Features Hardware Overview Front ViewReset Ethernet Connector Wireless Antenna Rear ViewHardware Installation Attach the AntennaAttach the Swivel Stand Connect the Ethernet CableAttach the External Power Supply Installation Wireless Installation Considerations Software Installation Click Setup WizardInstallation Installation Click Finish to complete the installation Installation Configuration Setup WizardConfiguration Click Restart Your setup is now completed Viewing Your Internet CameraConfiguration Setup Wizard Live VideoInternet Connection Setup Wizard Static IP Address, orConfiguration Network Setup This section, you can configure your network settingsSetup Wireless Wireless InterfaceSetup Ddns DdnsSetup Image Setup Image SettingsSetup Video Video ConfigurationSetup Mail Email AccountTime Schedule Interval Test E-mail AccountSetup FTP FTP ServerEnable upload image to FTP server Setup Time and Date Maintenance Device Management Maintenance Backup and Restore Maintenance Firmware Upgrade Status System ViewCam Installation Click D-ViewCamConfiguration Configuration Add a Camera Link D-ViewCamConfiguration DCS-910-55 DCS-910-55 DCS-910 Your D-ViewCam Installation is Complete Wireless Security What is WEP?What is WPA? Using & Configuring the DCS-910/920 Setting Up the DCS-910/920 For Use Behind a RouterAssign a Local IP Address to Your Camera Security Router Set-Up and Installation Access the Router with Your Web BrowserOpen Virtual Server Ports to Enable Remote Image Viewing Security Troubleshooting Why does the Power LED not light up constantly?Why does the LAN LED not light up properly? Why does the Internet Camera work locally but not remotely?Noisy images occur. How can I solve the problem? Why are no images available through the Web browser?Wireless Basics What is Wireless? Wireless Local Area Network WlanHome Small Office and Home OfficeCentralize your router or Access Point Eliminate InterferenceWireless Modes SecurityNetworking Basics Check your IP addressStep Highlight Internet Protocol TCP/IP and click Properties StepTechnical Specifications NetworkPower Consumption Link Technical Support over the Telephone Contacting Technical SupportLink Technical Support over the Internet Warranty Limited WarrantyLimited Software Warranty Non-Applicability of WarrantyWhat Is Not Covered Disclaimer of Other WarrantiesLimitation of Liability Governing LawTrademarks Copyright StatementCE Mark Warning FCC StatementRegistration