D-Link DCS-910/90 manual Hardware Installation, Attach the Antenna, Attach the Swivel Stand

Page 9

Section 1 - Product Overview

Hardware Installation

Attach the Antenna*

Locate the antenna included with your DCS-920 and attach it to the antenna connector located on the back of the DCS-920.

Note: It is required that an Ethernet cable is used during initial setup. Once your wireless configuration is set, you may disconnect the Ethernet cable and begin communicating wirelessly with your DCS-920.

Attach the Swivel Stand

Locate the stand mount on the back panel of the DCS-910/920 and screw on the swivel stand to the DCS-910/920.

Connect the Ethernet Cable

Connect the included Ethernet cable to the network cable connector located on the bottom panel of the DCS-910/920 and attach it to the network. Network Connectivity is confirmed when the green LED Indicator on the DCS-910/920, located below the Power LED, is illuminated.

* Wireless Antenna is provided with the DCS-920 only.

D-Link DCS-910/920 User Manual

Image 9

Contents Page Table of Contents Warranty Registration System Requirements Package ContentsIntroduction Features Front View Hardware OverviewRear View Reset Ethernet Connector Wireless AntennaAttach the Antenna Hardware InstallationAttach the Swivel Stand Connect the Ethernet CableAttach the External Power Supply Installation Wireless Installation Considerations Click Setup Wizard Software InstallationInstallation Installation Click Finish to complete the installation Installation Setup Wizard ConfigurationConfiguration Click Restart Viewing Your Internet Camera Your setup is now completedConfiguration Live Video Setup WizardStatic IP Address, or Internet Connection Setup WizardConfiguration This section, you can configure your network settings Network SetupWireless Interface Setup WirelessDdns Setup DdnsImage Settings Setup Image SetupVideo Configuration Setup VideoEmail Account Setup MailInterval Test E-mail Account Time ScheduleFTP Server Setup FTPEnable upload image to FTP server Setup Time and Date Maintenance Device Management Maintenance Backup and Restore Maintenance Firmware Upgrade Status System Click D-ViewCam ViewCam InstallationConfiguration Configuration Link D-ViewCam Add a CameraConfiguration DCS-910-55 DCS-910-55 DCS-910 Your D-ViewCam Installation is Complete What is WEP? Wireless SecurityWhat is WPA? Setting Up the DCS-910/920 For Use Behind a Router Using & Configuring the DCS-910/920Assign a Local IP Address to Your Camera Security Access the Router with Your Web Browser Router Set-Up and InstallationOpen Virtual Server Ports to Enable Remote Image Viewing Security Why does the Power LED not light up constantly? TroubleshootingWhy does the LAN LED not light up properly? Why does the Internet Camera work locally but not remotely?Why are no images available through the Web browser? Noisy images occur. How can I solve the problem?Wireless Basics Wireless Local Area Network Wlan What is Wireless?Small Office and Home Office HomeEliminate Interference Centralize your router or Access PointSecurity Wireless ModesCheck your IP address Networking BasicsStep Step Highlight Internet Protocol TCP/IP and click PropertiesNetwork Technical SpecificationsPower Consumption Contacting Technical Support Link Technical Support over the TelephoneLink Technical Support over the Internet Limited Warranty WarrantyNon-Applicability of Warranty Limited Software WarrantyDisclaimer of Other Warranties What Is Not CoveredGoverning Law Limitation of LiabilityTrademarks Copyright StatementFCC Statement CE Mark WarningRegistration